Simplex 4100-6052, 4010-9912, 4010-9816 Panel Mounted Digital Alarm Communicating Transmitters with Serial Communications (SDACT) (B) (C)

Status 864 listed per NFPA 72 National Fire Alarm Signaling Code for Central Station Service Operation is listed to UL Standard 1459 Telephone Refer to table on page 2 for additional information Registered to FCC Part 68 telephone line interface Requires Data Certified POTS lines Also compatible with DACT to Ethernet connection refer to compatibility list on page 2 internally to Simplex models For Network applications select a 4100ES or 4100U 4010ES 4100ES 4100U and 4010 for Network SDACT status reporting when specific building event information Communicates point status changes phone line status other off normal information Reports up to ten events per phone call programmable control for Automatic 24 hour test Power fail report delay status indicators include Panel LCD indicates off normal status Module LEDs provide service diagnostics DACT Simplex serial digital alarm communicating SDACT modules monitor the status of the host alarm control panel and its connections to the Central monitoring location When status changes require to be reported the SDACT provides detailed that can assist the Central Station in accurately the required response Typical information include alarms troubles and supervisory Model series 4010ES 4100ES 4100U and provide specific point information modules directly communicates with the fire alarm panel CPU and are custom programmed for the requirements of the Central Station and the fire alarm control panel Refer to individual fire alarm control panel data sheets and receiving DACR product for additional listing status Contact your local Simplex product supplier for information Listings and approvals under Simplex Time Recorder Co are the of Tyco Fire Protection Products Accessories Mounted Digital Alarm Communicating with Serial Communications SDACT Station message with location and action per application requirement ALARM MIDDLE SCHOOL BOILER ROOM SMITH ROAD SPRINGFIELD ABLE 555 9876 SMITH 555 9978 Station Service SUPPLY ROOM telephone connections connectors Fire Alarm Control Panel Shown for Reference Application Diagram Reporting Formats Contact ID CID CID is the preferred format for operation It provides a four digit account code by a three digit event code a two hex digit number and a three hex digit contact number all which are used to encode specific point identification Pulse A three digit account code followed by a one reporting code Transmissions are sent as a double at a rate of 20 PPS pulses per second Reporting are programmable Pulse Similar to 3 1 except for a four digit account and a two digit reporting code Transmission is sent a double round at 20 PPS Report codes are Three digits of account code and two digits of code in a single transmission of constant tones format has built in error checking so that a double is not required Reporting codes are fixed Security Industry Association SIA Digital Standard The SDACT provides level 1 which includes tonal acknowledge basic only and fixed reporting codes 9 2012 SDACT Product Selection and Reference Alarm Panel Data Sheet 4100ES and 4100U Mounted Digital Alarm Communicating with Serial Communications SDACT Specifications Capacity VDC from panel 30 mA Report Mode 40 mA points maximum Information received is determined by capability of the digital alarm communicating DACR and communication format used to 2 4100 6052 SDACTs can be selected F to 120 F 0 C to 49 C RH 85 F 30 C SDACT Capacity Temperature Humidity Requirements Registration 2 required Type start pulse or tone dialing Data Certified POTS lines SDACT Cables with Plug two are required and are included with the panel per below ft long 4.3 m included with 4100 6052 4100ES and 4010 9912 4010ES with RJ 45 plug to spade lugs ft long 2.1 m included with 4010 9816 4010 terminated with RJ 45 plug each end Communication Format Compatible ID Standard Hz and 20 Standard Hz and 20 Standard Hz and 20 Standard Hz and 20 Hz Hz Knight 9000 9032 line card 9032 line card 9032 line card 9032 line card 9032 line card 9032 line card 2080 9047 SDACT DACR Compatibility Reference Model II 685 with Line Card CP220FB with Line Card Radionics Radionics TL300 ULC listed C900V2 listed With or without D6680 Network Ethernet Adapter in D6600 DACT to Ethernet connection interfaces line SIMPLEX and the product names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm and Code are registered trademarks of the National Fire Protection Association NFPA 2012 Tyco Fire Protection Products All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Fire Protection Products Westminster MA 01441 0001 USA 9 2012