Simplex 4100-9930 through -9939 Retrofit kits for installing 4100ES equipment into existing AUTOCALL control panel backboxes (B)

CSFM Listed FM Approved NYC Acceptance Control Panels Kits for Installing 4100ES Equipment into AUTOCALL Control Panel Backboxes existing AUTOCALL fire alarm control equipment with Simplex 4100ES Series using the existing backbox Retrofit kits include either a solid or glass door panels for glass door applications and box hardware Kits are available to accommodate 1 2 or 3 bays 4100ES equipment Doors and trim are red See notes on page 2 for installation tool the retrofit kits in place standard 4100ES can be easily installed Existing cabinets accommodate internal battery up to 33 Ah ref battery 2081 9276 Ah or higher battery sizes require external Established 4100ES module placement rules apply existing backboxes include Five module seven module or ten module height 4 102 mm or 6 152 mm deep boxes Boxes with or without top and bottom mounting kit includes adapter brackets for boxes the flanges Listed to Standard 864 When existing fire alarm control systems capacity or performance increases it is an to consider new product solutions For AUTOCALL fire alarm control equipment in of updating these retrofit kits allow the installation 4100ES Series equipment to be mounted in the box By retaining the existing boxes mechanical electrical impact is reduced often significantly Applications Examples for these retrofit kits backboxes installed on surfaces that would be to modify such as marble plaster or concrete or installed into a custom enclosure Whether surface or semi flush mounted these retrofit kits can the equipment retrofit process Selection Reminder Proper retrofitting existing equipment requires that the desired fire alarm be understood in order to specify the necessary equipment Application 7 Module Box with Two Bay 4100ES This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing 7170 0026 251 allowable values and or conditions concerning material presented in this document It is to re examination revision and possible cancellation Accepted for use City of York Department of Buildings MEA35 93E This product was not ULC listed as of revision date Additional listings may be applicable contact your local Simplex supplier for the latest status Listings and approvals under Simplex Time Recorder are the property of Tyco Safety Products Westminster AUTOCALL 7 Module Equipment Box4100ES Equipment mounts with 7 module Retrofit Kit sized to fit existing boxExisting equipment and door assembly are removed firealarmresources com Box Depth Box Model No Box Capacity Module Capacity AUTOCALL Backbox Retrofit Kit Selection Retrofit Kits with Glass Door 102 mm 152 mm 102 mm 152 mm 152 mm 102 mm 152 mm 102 mm 152 mm 152 mm Module bay Module Module bay bay Module bay Module Module bay bay Retrofit Kits with Solid Door Box Depth Box Model No Box Capacity Module Capacity AUTOCALL Retrofit Kit Installation Reference for details refer to Installation Instructions 579 798 box extension bracket top of box if Notes Power tools are required Pilot holes must be drilled in the of the existing box using a drill bit Mark hole locations the extension hardware as a remove extension before drilling Self tapping screws fasten the hardware to the box a to heavy duty power is recommended an long driver is recommended for deep boxes Refer to Installation Instructions for more information assembly or solid door shown panel for doors is a registered trademark of Tyco International Services GmbH and is used under license Simplex the Simplex logo and AUTOCALL are trademarks of Tyco International Ltd its affiliates and are used under license 2011 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA bay brackets bracket bottom of if required