Simplex 4100ES Fire Control Panels 4100ES Addressable Fire Detection and Control Emergency Voice Alarm Communications Equipment

UL ULC CSFM Listed FM Approved Approved Fire Control Panels Addressable Fire Detection and Control Emergency Voice Alarm Communications voice alarm communications provide Alarm evacuation signal generation with multiple built in tones Standard or customized digital message storage and message Automatic or manual operation Mass Notification operation channels are available Analog audio systems provide dual channel operation Digital audio systems provide up to eight channels over a single wire features Up to five supervised remote microphone inputs Spoken voice coding from the digital message player Multiple digitally recorded human voice messages Spoken WALKTEST system testing Separate evacuation drill and optional All Clear voice messages and Ready to talk microphone indicator on front panel audio control Local panel speaker for tone message broadcast verification MINIPLEX Voice Transponders are available for distributed audio are available with analog or digital input Flex 35 35 W and Flex 50 50 W amplifiers provide a dual channel with configurable operation modes 100 W primary and backup single channel amplifiers include a built in supply Amplifiers are available for 25 VRMS or 70.7 VRMS output with on power limited NACs only one voltage choice per system Built in Temporal Pattern horn tone provides default backup signal Optional modules provide power limited NAC expansion convert B NACs to Class A operation and provide Constant Supervision for Non Alarm Audio NAA applications NAA requires hardware and software revision 11.08 or higher telephone systems Master telephone can simultaneously talk with up to 6 remote and can be connected as an audio input for broadcast Ring signal on remote firefighter telephone indicates that a call request initiated and a hold signal indicates that a connected line has been Telephone circuits are supervised for open and short circuits too many connected and the master telephone is supervised for integrity Degraded mode allows remote telephones to remain connected to other in the event of a communications loss 1 4100ES Fire Alarm Control Panel with Touch Screen Display and Voice Options information UL 864 Fire Detection and Control UOJZ Smoke Control Service Releasing Device Service SYZV Emergency Communication Relocation Equipment UOQY UL 1076 Proprietary Alarm Units Burglar APOU UL 2017 Process Management Equipment QVAX Emergency Alarm Control Units FSZI UL 1730 Smoke Detector Monitor UULH UL 2572 Mass Notification Systems PGWM CAN ULC S527 Control Units for Fire Alarm Systems UOJZ7 Releasing Service SYZV7 CAN ULC S559 Central Station Fire Alarm System Units DAYR7 ULC ORD C1076 Proprietary Burglar Alarm Units and Systems APOU7 ULC ORD C100 Smoke Control System Equipment UUKL7 Audio Systems Audio Systems provide voice communication alarm tones and digitally prerecorded voice messages to alert occupants of fire or emergency situations Evacuation signaling may be automatically via alarm initiated event programs or by firefighting personnel the operator controls Controller Module Description Audio Controller Module provides digitized alarm tones and recorded voice messages and message construction and both microphone inputs and other auxiliary inputs connected the optional Auxiliary Audio Input Module Tones and voice messages digitally recorded and stored in the audio control module message This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7165 0026 251 for allowable and or conditions concerning material presented in this document Accepted for use City of New York Department of Buildings MEA35 93E Additional listings may be applicable contact your Simplex product supplier for the latest status S4100 1034 Rev 7 2 2022 Addressable Fire Detection and Control Emergency Voice Alarm Communications Equipment Slow Whoop a slowly ascending tone High Low with high frequency of 750 Hz for 100 ms and low of 500 Hz for 400 ms Beep 500 Hz tone of 0.7 s on 0.7 s off Stutter 500 Hz tone with on and off times of 100 ms Wail ascends then descends between 600 to 940 Hz GSA Tone continuous 2000 Hz tone Controller Message Description Coded Signaling is available using tones or spoken numbers coded messages can be used in place of conventional pulse coding to eliminate counting and interpretation of the zone coded For example a fire alarm zone such as First Floor East Smoke Room 23 will be Code 1123 possible transmission schemes are Conventional Zone Coded Signaling where T Tone Spoken Coded Signaling Code one one two three Code Audio Controller has the ability to precede spoken codes with and alert tones As an alternative the previous example could been preceded with a chime tone The word code could be with the phrase Doctor Firestone please dial Special Messages can be ordered Up to 32 of special phrases and messages are available to meet applications The standard Evacuation Message is Attention Attention An emergency has been reported All occupants to the nearest stairway exit and walk down to your assigned re floor or main lobby Do not use the elevator Walk to the nearest Do not use the elevator Walk to the nearest stairway Message Ordering is summarized below 1 Custom Message Ordering when Custom Messages are required choose types from below as required quantity of one Messages from Messages from NOTE Send in advance to Engineering to phrase quantity Messages from Relocation Message Temporal 4 Pattern horn with English male voice instruction identify as when ordering 1 4100 082x for 2 complete messages spliced phrases for each 50 spliced versions are available Analog and Digital Systems must be either or digital not intermixed One audio control module controls the audio system audio control board features On board digital message memory provides up to 2 minutes at normal 1 minute at high resolution Connects to optional 4 input audio input modules two maximum for total of up to 6 microphones and 11 distinct audio inputs Memory expansion is available to provide up to 8 minutes or 32 at normal resolution 4 minutes or 16 minutes at high Connections for a Master Microphone and one Remote Microphone with standard or noise canceling microphones Master telephone to audio interface connection uses the audio bay Distribution Interface Module PDI Local panel speaker output with on board volume control On board download port for message loading The microphone ready to talk LED is located on the front panel audio module see p 4 and requires connection to a 64 LED 64 controller Audio risers either digital or analog may be directly connected to 31 nodes for applications requiring audio risers to more than 31 nodes alternate connection methods are available contact Simplex product representative for details Audio Controller Modules audio control modules are for systems that require one two simultaneous channels of audio information per the following summary Built in 10 VRMS riser output eliminates the need for separate riser available as Class B or Class A Messages can play on one or both risers simultaneously with the same a different message Analog audio controllers are for connection to analog input audio and audio risers only On board status LEDs assist with setup and troubleshooting Audio Controller Modules audio control modules are for systems that require more two simultaneous channels of audio information per the following summary