Simplex 4190-0015-1 CCU3-C4-4100, CCU3-C4-ISIB, CCU3-C4-INA, CCU3-C4I-HUB, CCU3-C4-HUB, CCU3-IO-UL, CCU3-C4-XLG, 4190-9810 Fire Network Integration; Communication Control Unit Network Integration (CCUNET) (A)

ULC Listed integrates multiple fire alarm control platforms into an XL Graphics Command based network to provide System wide annunciation and limited control of fire protection systems both addressable and Dual redundant communication loops deliver transparent routing around breakages and failures in the A flexible network design with support for multiple loop provides interconnection using Control Unit CCU Modules CCU modules implement CCUNET data via RS 422 full duplex operation Each CCU module is self contained with pluggable block connections LED status indication and a local Form C relay output Mounting is in dedicated box model 4190 9810 that can easily located close to the connected control panel Up to 105 CCUNET modules are supported per network Fire Alarm Panels and Networks include Simplex 4100U stand alone and Network connected alarm control panels Notifier AM2020 and INA fire alarm control panels SIBNET and INA interfaces Conventional fire alarm control panels using HUB modules with I O Expansion modules products combined with XL Graphics color software provide fire network integration for fire networks protocols This Network approach results in rapid and effective and limited control to replace stand alone fire control panel performance Point to Point Operation CCUNET is multi point point to point network which allows data to be simultaneously transmitted between on the network All network segments transmit and simultaneously which greatly increases network and Packet Processing Each CCUNET has routing and packet processing capability which Network segment failure isolation and fast data via routing tables This product was not approved by FM MEA NYC or CSFM as of document revision date listings may be applicable contact your local Simplex product supplier for the status Listings and approvals under Simplex Time Recorder Co are the property of Safety Products Westminster Network Integration Control Unit Integration CCUNET YS TEM UPE RV ISORY ST EM ARM ILENCED OWE R UBLE K S ENU LE SCONNEC T ATTER Y A ND C POWER E ING YS TEM UP ERV ISORY ST EM ARM ILENCED OWE R RM CK CK UBLE K M ESET ENU ISA BLE TION HI KL SCONNEC T TTER Y A ND C POWER E ING Graphics Workstation Interface Modules Provide Network Compatibility for a variety of Fire Alarm and Networks Operation XL Graphics Command Center Workstations Alarms Supervisories Troubles Disarmed etc for each connected fire alarm control panel to the CCUNET Network It provides controls the connected panels such as for Acknowledge Alarm Reset initiate diagnostic testing etc Network Event annunciation information from the panels is routed via direct paths through the The XL Graphics Workstation acts on the first to arrive discarding subsequent duplicate event Under normal operation XL Graphics will the event message from two paths This ensures in the event of a fatal network error cable break or non fatal error packet corrupted event annunciation is impacted or postponed Single Operator located at the XLG can supervise the fire systems individual panels via CCUNET modules The modules interpret transfer information from the panels and facilitate fire panel control based upon safety agency and panel interface functionality FACP connections support both high level and low level printer port or hard contacts allows the XL Graphics Workstation to provide a range of fire alarm control panel monitoring and control 3 2008 Information CCUNET Product Selection Ordering Information PID CCU3 C Module with 4100 Firmware CCU3 C Module with ISIB Firmware CCU3 C Module with INA Firmware CCU3 C Module with HUB Firmware CCU3 IO UL I O Expansion Module Output Connectors Input Connectors to Simplex 4100U fire alarm panel to Notifier AM2020 Interface alarm control panel to Notifier INA fire alarm panel network module includes a Form C relay output operation to indicate of communication ground fault on 1 2 3 4 Connection Module with I O Expansion Module for 4 20 mA to non addressable conventional fire alarm control can accept up to one additional CCU3 IO UL module CCU3 C Module with HUB Firmware Hub Connection Module I O Expansion module for Hub connection Installation and Configuration Module Input Connectors Output Relay Connectors Mounting Screws CCU3 C Module with XLG Firmware CCU3 Programming Cable Interface Adaptor with harness Audible Supervision Module with harness Box red surface mount one required to mount each CCU module dimensions 9 1 2 W x 7 1 2 H x 3 1 4 D 241 mm x 191 mm x 83 mm CCU3 C4I HUB I O expansion or service replacement to 2 maximum per CCU3 C4 HUB module provides supervised inputs and 4 relay outputs selectable as NO or NC XLG Workstation to the CCUNET Network detailed XLG XLGraphics information refer to data sheet Common Parts Included with these modules Power connector Supervision relay connector Alarm input connector Communication port connectors Installation and Configuration Manual Complimentary screwdriver Typical Application Application University Example Simplex Notifier and Conventional non fire alarm systems are located in the Squash Courts and Student Union as shown in the diagram to the right supervision was performed by individual housed in the respective buildings In the new Arts building is desired to be using a new Simplex Network It is a very building and will require multiple 4100U fire control panels for proper coverage buildings are to be monitored and controlled the Fire and Security Center as indicated by the Building Building Notifier Union Notifier and Center Simplex Panel Annunciation control point Building Courts Simplex Network Fire Panels 3 2008 Typical Application CCUNET Solution this application the CCUNET solution shown integrates the following A Notifier AM2020 fire alarm control panel based in the Administration Building with INA requiring one CCU3 C4 INA module Notifier AM2020 fire alarm control panel in the Building with ISIB communications one CCU3 C4 ISIB module A new Simplex 4100U based Network in the Arts connecting at a 4100U NDU Network Display and one Simplex 4100U FACP in the Student Building each requiring one CCU3 C4 4100 The Squash Courts are equipped with conventional fire alarm control panels and will using the contact closure interface CCU3 C4 HUB module with I O module CCU3 IO UL Each interface module would be housed in a model box located within 5 ft 1.5 m of the fire alarm control equipment 4100U Fire Alarm Control Panel Point When connected to a Simplex 4100U fire control panel up to 2000 CCUNET Network points be annunciated When connected to a Simplex 4100U up to 12,000 network points can be annunciated Building Building panels Building