Simplex 4901-9858, 4901-9859 SmartSync 2-Wire Operation, Non-Addressable Mini-Horn (F)
File Preview
Click below to download for free
Click below to download for free
File Data
Name | simplex-4901-9858-4901-9859-smartsync-2-wire-operation-non-addressable-mini-horn-f-8634512790.pdf |
---|---|
Type | |
Size | 635.80 KB |
Downloads |
Text Preview
ULC CSFM Listed FM Approved current 24 VDC electronic mini horn provides Operation with Simplex SmartSync 2 wire control Small profile horn packaged in a rugged high impact retardant thermoplastic housing available in red white Snap on cover presents a clean and neat appearance Convenient mounting to a single gang electrical box requires a tool or surface mounted two wire control of audible and notification appliance provides Control of mini horn tone as Temporal Pattern March pattern DIP Switch selectable for 60 BPM or BPM or on continuously controlled separately from appliances on the same circuit Visible appliances on the same SmartSync circuit at a synchronized 1 Hz flash rate Operation that allows and on the same two wire pair reference UL listed to Standard 464 ULC listed to Standard S525 Mini horns provide a loud and penetrating notification controlled by SmartSync two wire operation The package allows mounting in a variety of locations An output level switch allows of low or high sound output as required for the see specifications for details operation mode allows a two wire circuit activate both the horn and strobe on the same NAC appliance circuit and then allows the horn to silenced while the strobe remains flashing The horn as while the strobe operation two wire control is available from 4006 4008 4100U and 4010 Fire Alarm Control refer to individual product data sheets for more 4009 IDNet NAC Extenders refer to data sheet SmartSync Control Module SCM Model 4905 9938 to data sheet S4905 0003 two stage alarm applications A second position allows the SmartSync March Time pattern to be selected as either 60 BPM or 20 BPM 20 BPM typically required for Canadian two stage alarm as the pre signal followed by the Temporal Two stage alarm operation requires a 4010 or as the control panel Appliances 2 Wire Operation Mini Horns Mini Horn Front and Side View Selection Red Mini Horn White Mini Horn Voltage Range 16 VDC to 33 VDC Rating Range Range mA maximum H x 2 3 4 W x 1 1 4 D mm x 69 mm x 32 mm to 122 F 0 to 50 C to 93 non condensing 100 F 38 C blocks for 18 AWG to AWG 0.82 mm2 to 3.31 mm2 two per terminal for in out wiring Output Ratings Level Test Chamber Test UL 464 10 ft 3 m Chamber Test ULC S525 3 m 10 ft Dispersion Reference ULC S525 Level Selection dBA dBA dBA dBA dBA at 40 off axis dBA at 85 off axis The low level setting is not suitable for ULC fire applications is for private mode applications per UL 464 Always test sound level against local requirements This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing for allowable values and or conditions concerning material presented in document It is subject to re examination revision and possible cancellation listings may be applicable contact your local Simplex product supplier for the status Listings and approvals under Simplex Time Recorder Co are the property Tyco Safety Products Westminster SmartSync two wire horn strobe operation is protected under U S Patent No 6,281,789 4 2010 Installation Reference additional information refer to Installation Instructions 579 870 Settings DIP Switch located behind cover Output 1 2 March Time Pattern 20 BPM beats per minute is typically used for Canadian Time Pattern Output 20 BPM 60 BPM 69 mm mm mm mm mm into single gang 1 1 2 38 mm depth 44 mm is removable tool required for access mounting screws and DIP Switch selections operation mode and sound level screwdriver at bottom of to tighten terminal screws wires are in slots at of housing and into terminals Use top bottom rear of box for wiring side entrance not available is a registered trademark of Tyco International Services GmbH and is used under license Simplex the Simplex logo IDNet and SmartSync are trademarks of Tyco Ltd and its affiliates and are used under license 2010 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA 4 2010