Simplex 4905-9815, 4905-9817, 4905-9818

ULC CSFM Listed FM Approved NYC Acceptance Notification Appliances Adapter Module for Non Addressable Appliance Circuits NACs Model 4905 9815 a SmartSync NAC into separate 24 VDC and visible appliance outputs Power and communications are supplied by the operation NAC Up to two SmartSync Adapter Modules can be to a SmartSync NAC is compatible with SmartSync control the following Simplex control panels Fire alarm control panels directly providing SmartSync horn strobe control Model 4010 fire alarm control panels and 4009 IDNet Extenders using the 4905 9938 SmartSync Control for Class A SmartSync operation control output features Operation modes are visible and audible appliances on or visible appliance only with activation by the connected control panel On board circuit limits appliance inrush current and self resetting overcurrent protection Wiring to audible and visible appliances is supervised conventional reverse polarity operation opens or are reported to the control panel diagnostics A visible status LED will light if a wiring fault is by either of the on board output notification supervision circuits output ratings Regulated 24 DC appliance power audible output is for up to 30 mA visible output is rated for up to mA Special Applications appliance ratings audible output rated for up to 50 mA visible output is rated for up 250 mA mechanical features Mounts in standard 4 11 16 119 mm square electrical Cover plates required are available for surface or flush ordered separately Covers provide status LED viewing Screw terminals for wiring connections listed to Standard 864 This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing for allowable values and or conditions concerning material presented in document It is subject to re examination revision and possible cancellation for use City of New York Department of Buildings MEA35 93E Additional may be applicable contact your local Simplex product supplier for the latest Listings and approvals under Simplex Time Recorder Co are the property of Tyco Products Westminster appliance appliance with SmartSync 2 wire operation alarm control panel providing operation NACs style shown for reference Control Adapter Module One Line Wiring Reference Notification Requirements Standard operation notification appliances activate and or strobes in response to commands received the SmartSync operation control source using a connection For applications where appliances than the standard SmartSync appliances are the SmartSync Adapter Module provides a audible and visible output controlled by the operation control source applications are for connection to special appliances appliances with particular output characteristics special bells or chimes or connection to appliances that are required to satisfy aesthetic requirements SmartSync operation System With the SmartSync Adapter Module appliances can be controlled while still from the SmartSync operation ability to separate audible and visible control using a connection U S Patent No 6,281,789 additional information refer to Installation 579 391 2 2010 Appliance Wiring Details with circuit protectors When to remote appliances up to 200 ft from the that exit the building and may be exposed to electrical environments the notification appliance is compatible with Simplex circuit protectors protectors are listed on page 3 and should be both where the wiring leaves the building and it connects to the appliances TrueAlert Adapter Product Selection for shielded wire For applications where appliance wiring may be exposed to electrical twisted shielded wiring is recommended The wiring terminal block has provisions for the shield s Adapter Module requires surface or flush mount cover plate Resistor Harness ref 733 894 10 k 1 2 W two required one each for audible and visible Mount Cover Plate Mount Cover Plate one for each 4905 9815 painted beige TrueAlert Adapter Installation Reference plate depth 9 mm for surface mounted box 6 mm for flush mounted box 119 mm square box 2 51 mm depth ref RACO 257 2 1 8 mm deep or equal supplied by others LED Adapter Assembly pipe for viewing 133 mm Adapter Module Detail holes cover plate 4 block for connections for connecting mounting box 4 mm into box 33 mm mode switch PATTERN POWER SERVICING 127 mm 2 2010 Specifications Voltage Current Voltage NAC Ratings 24 DC Appliances Application Appliances Reference Distance from SmartSync Adapter Resistor Connections Circuit Protection when wiring leaves the building for appliances mount one at each end of and Environmental adapter mounted in bracket see 2 for reference drawing Plate Material Range Range to 33 VDC see notes 1 and 2 below 100 maximum 450 mA maximum adapter and appliances 24 DC Power Ratings Application Ratings to 32 VDC appliance inrush current is internally limited to 550 mA Output 30 mA Output 180 mA Output 50 mA Output 250 mA for appliances listed to UL Standard 1971 or UL Standard 464 use external synchronization modules where required conventional non addressable 4901 4903 4904 and 4906 Series strobes and combination horn strobes and speaker strobes contact your product representative for compatible appliances ft maximum 61 m k 1 2 W two required one located at each remote appliance use End of Line Resistor Harness ref 733 894 ordered separately terminals for 18 to 12 AWG 0.82 mm2 to 3.31 mm2 Overvoltage Protector 200 mA maximum Isolated Loop Circuit Protector 5 A maximum Isolated Loop Circuit Protector 200 mA maximum H x 5 W x 1 9 32 D 119 mm x 127 mm x 33 mm metal galvanized to 120 F 0 to 49 C intended for indoor operation to 90 RH non condensing at 90 F 32 C The SmartSync adapter is required to be connected to a NAC that provides SmartSync two wire operation The rated voltage range listed is the absolute operating range Operation outside of this range may cause permanent damage the SmartSync adapter 2 2010 is a registered trademark of Tyco International Services GmbH and is used under license Simplex the Simplex logo SmartSync and IDNet are trademarks of Tyco Ltd and its affiliates and are used under license 2010 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA 2 2010