Simplex 4906-9137, 4906-9138 SmartSync Operation Audible Visible Notification with Multi-Tone Horn and Synchronized Flash, Non-Addressable (F)

ULC CSFM Listed Approved Multi Candela Notification Appliances Operation Audible Visible Notification with Horn and Synchronized Flash Non Addressable wall mount notification appliances electronic multi tone horn and high output strobe Strobe operation is compatible with ADA requirements to important installation information on page 3 Rugged high impact flame retardant thermoplastic are available in red or white with clear lens over a two wire Simplex SmartSync to provide Horn tones controlled separately from strobes on the two wire circuit with and operation on the same two wire pair Strobe appliances on the same circuit operating at a 1 Hz flash rate refer to page 2 for SmartSync control information and panel notification appliance multi tone horn Low current 24 VDC electronic multi tone horn with appliance tone selection of Horn Bell 500 Hz Canadian Horn Slow Whoop Siren or Hi Lo using an on board DIP Switch Slow Whoop Siren and Hi Lo tone selections sound tones continuously synchronized to each other receiving Temporal Pattern March Time or SmartSync commands SmartSync March Time pattern produces a 60 BPM for the Horn 500 Hz Horn and the Bell tone Horn produces a 20 BPM output from the March Time pattern command Output level selectable as standard or high refer to output details on page 3 Listed to UL 464 and ULC S525 notification appliance strobe 24 VDC xenon strobe intensity is selectable as 15 30 or 110 candela with visible selection jumper secured strobe housing Regulated circuit design ensures consistent flash output provides controlled inrush current Listed to UL 1971 and ULC S526 mount multi tone horn strobes features Wiring terminals are accessible from the front of the providing easy access for installation and testing Covers are available separately to convert housing color Optional UL ULC listed sound damper for locations attenuation of 5 to 6 dBA stairwells small highly reverberant areas etc Adapters are available to cover surface mounted boxes and to adapt to Simplex 2975 9145 UL listed red wire guards are available Horn Strobes Multi Candela TrueAlert multi tone horn strobes convenient wall mounted installation to standard boxes Tone selection and output level is set per allowing notification needs to be tailored to area requirements Refer to tone output details on 3 Tone Selection DIP Switch selection determines local tone choice Selecting Canadian Horn allows the March Time pattern input to be produced as BPM typically required for Canadian two stage alarm as the pre signal followed by the Temporal A separate DIP Switch position allows selection of standard or a high output sound level selectable to the location See page 3 for sound output designs are both impact and vandal resistant provide a convenient strobe intensity selection Since model can be selected for strobe intensity output and tone output on site model inventory is minimized changes encountered during construction can be easily mount multi tone horn strobe housings are a assembly including lens that mounts to a single double gang or 4 square standard electrical box The can be quickly removed a tool is required and are available separately for color conversion Intensity Selection installation a selection plug at the back of the determines the desired strobe intensity An flag with black letters on a highly visible yellow allows the selected intensity to be seen at the of the strobe lens Refer to page 2 for guard listing This product has been approved by the California State Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety See CSFM Listing 7135 0026 335 for allowable values and or conditions material presented in this document It is subject to re examination revision possible cancellation Additional listings may be applicable contact your local product supplier for the latest status Listings and approvals under Simplex Recorder Co are the property of Tyco Safety Products Westminster Simplex multi candela SmartSync two wire multi tone horn strobe appliance operation is under one or more of the following U S Patent Numbers 5,559,492 5,865,527 5,886,620 6,281,789 6,954,137 7,005,971 and 7,006,003 4 2010 SmartSync Two Wire Control operation mode allows a two wire circuit to the ability to activate both the multi tone horn strobe on the same NAC and then allow the multi horn to be silenced while the strobe remains flashing multi tone horn operates as while strobe operation is SmartSync Control Sources 4006 4008 4100U and 4010 Fire Alarm Control refer to individual product data sheets for more 4009 IDNet NAC Extender refer to data sheet SmartSync Control Module SCM 4905 9938 refer to sheet S4905 0003 SmartSync compatible notification include separate multi tone horns and multi tone horn strobe notification appliances Strobe Application Selection selection of visible notification is dependent on location local codes and proper applications the National Fire Alarm Code NFPA 72 ANSI the appropriate model building code BOCA or SBCCI and the application guidelines of the with Disabilities Act ADA Strobes Strobes When multiple strobes and their can be seen from one location synchronized reduce the probability of photo sensitive reactions well as the annoyance and possible distraction of flashing The multi candela strobes of these horn strobes are synchronized by the SmartSync operation NAC Product Selection Multi Tone Horn Strobes Description Mount Multi Tone Horn Strobe Accessories mounted electronic multi tone horn with multi candela strobe strobe intensity as 15 30 75 or 110 candela operates with SmartSync two wire control Red White Red Adapter Plate for mounting to Simplex 2975 9145 box typically for Mount Adapter Skirt use to cover 1 1 2 38 mm deep mounted boxes may be mounted vertical or horizontal Red Mounting Box requires Adapter Plate 4905 9931 Sound Damper package of 20 field installed adhesive backed output attenuator reduces output 5 to 6 dBA After Sound Damper installation measure sound level to ensure with applicable code requirements Control Module SmartSync Control Module with Class B or Class A output mounts in 4 Covers for Wall Mount Multi Tone Horn Strobes mm square box refer to data sheet S4905 0003 for details Red cover with white lettering White cover with red lettering Guard Wall mount red wire guard with mounting plate compatible with semi flush UL listed by Space Age Electronics Inc surface mounted boxes H x 5 1 4 W x 1 5 8 D mm x 133 mm x 41 mm with strobe 4 3 8 111 mm x 5 3 4 x 0.060 Thick mm x 146 mm x 1.5 mm x 5 1 8 x 2 3 4 D mm x 130 mm x 70 mm Diameter 44.5 mm 0.31 8 mm sound opening x 4 1 8 x 1 1 4 D mm x 105 mm x 32 mm H x 5 W x 1 1 2 D mm x 127 mm x 38 mm H x 6 1 16 W x 3 1 8 D mm x 154 mm x 79 mm 4 2010 Multi tone Horn Strobe Specifications Specifications Voltage Range Rate and Synchronized NAC Loading Temperature and Humidity