Simplex Access control Communication Option for the 3500 Series Intelligent System controller (ISC)

ISC is a modular intelligent control panel for the Pro Intelligent Security Management System It distributed information processing at remote and supports interfaces to a variety of peripheral devices passive backplane architecture of the Simplex System Controller ISC allows each ISC to be to meet specific communication requirements ISC can be configured with one of three different mounted communication interface cards that available for use with the ISC 4120 type Network Simplex 4120 Network is a supervised fault tolerant that may be wired in an open ended Style 4 or loop Style 7 configuration It supports peer to communications between ISCs Hardwired Network Card 3500 9804 4120 Hardwired Network Card supports 4120 over shielded twisted copper pairs Compatible with Simplex isolated loop and Earth detection protectors Hardwired Network Card Controller Options for the ISC Modular Network Card 3500 9805 4120 Modular Network Card uses plug on media to support communication via shielded twisted pairs fiber optics or mixed copper fiber Hardwire Copper Media Module 3500 9806 Fiber Optic Media Module 3500 9807 Style 7 Class A or Style 4 Class B operation Fiber optic links provide immunity to electrical short circuits and ground conditions provided with type ST connectors with 62.5 125 or 50 125 multimode fiber Modular Network Card Internal Modem Card 3500 9815 ISC Dial up Modem provides communications with iSecure Pro Servers via the public switched network using dedicated dial up POTS Plain Telephone Service or powered loop leased lines iSecure Pro V3.0 or later software Compatible with telephone company POTS and leased lines not PBX circuits Modular RJ 11 connectors Internal Modem Card 2002 TEPG US All rights reserved 05 02 Selection and ISC Power Requirements Hardwired Communications Distances Size and Specifications AWG Twisted Shielded Pair 58 pF ft 6.39 AWG Telephone Cable 22pF ft With overall shield With or without isolated loop or overvoltage protectors Fiber Optic Cable Communication Distances Hardwire Card Modular Card Internal Modem 5 VDC mA mA mA Rate ft 3 km ft 2.1 km dB Type cid 1 numerical aperture 0.2 dB km dB km dB km dB km Margin dB dB dB dB ft 3.05 km ft 4.57 km ft 3.96 km ft 4.57 km numerical Cable specifications are for 50 or 62.5 micron core with 125 micron cladding multi mode graded index fiber Wavelength 850 nm MIFL Maximum Individual Fiber Loss Numbers shown are for example reference only Refer to specific cable for exact specification Maximum cable length is determined by distance listed or by reaching budget value whichever is shorter Maximum distances listed for dual fiber cable are shorter than would be calculated Communications Requirements dB Telephone Lines Type Telephone Lines 9600 baud Requirements Analog Powered Loop with dial 2 wire RJ 11 Termination Requirements Analog POTS Plain Old Service Can not be used with PBX equipment ISC telephone lines require unique telephone numbers and dedicated connections Simplex the Simplex logo and iSecure are either trademarks or registered trademarks of Tyco International Services AG its affiliates in the US and or other countries Microsoft and Windows are registered trademarks of Microsoft Corporation All trademarks are property of their respective owners 5 02 Massachusetts 01441 0001 USA us on the world wide web at www simplexnet com specifications and other information shown were current as of printing and are subject to change without notice