Simplex Batteries and Chargers, 4081 Series Battery Cabinet with Charger
File Preview
Click below to download for free
Click below to download for free
File Data
Name | simplex-batteries-and-chargers-4081-series-battery-cabinet-with-charger-9613045872.pdf |
---|---|
Type | |
Size | 759.68 KB |
Downloads |
Text Preview
UL CSFM Listed FM Approved battery cabinet with charger for compatible systems batteries larger than the control panel cabinet For use with Simplex 4010 Fire Alarm Control Unit FACU or Model Agent Release Control unit Accommodates batteries up to 50 Ah ordered separately Cabinets mount close nippled to fire alarm control cabinet and can be either on the surface of or semi flush to the cabinet FACUs are selectable for depleted battery warning or depleted battery Available with beige or red cabinet connection controls charging circuit FACUs periodically disable the charger and perform a battery test to battery condition Missing batteries or low battery charge problems are identified and as troubles at the FACU 4010 FACUs batteries allow up to 25 Ah to be mounted within cabinet Simplex 4004R Agent Release Control Panels allow up to 12.7 Ah to be mounted within their cabinet For system requiring more battery backup the external 4081 Series cabinets with charger can accommodate batteries up to 50 Ah status monitoring separate wired connection to the FACU allows the remote charger to be disabled allowing the FACU to evaluate battery status such as missing or low batteries are reported as troubles at FACU battery battery warnings and selectable or standard battery cutout of the connected FACUs are maintained when connected to the remote battery charger Accessories Series Battery Cabinet with Charger 1 series battery cabinet with charger 1 General specifications type and capacity output voltage power requirements and mechanical range range connections requirements from FACU Installation reference lead acid only up to 50 Ah ordered separately 24 VDC VAC to 132 VAC 60 Hz A at 120 VAC to 122 0 to 50 to 93 RH non condensing at 38 maximum blocks for up to 12 AWG 3.31 mm wires for battery connections additional wire required for control ft 6 m maximum 1 2 in W x 16 3 4 in H x 8 3 8 D 572 mm x 425 mm x 213 90 lb 41 kg with 50 batteries This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7315 0026 228 for allowable and or conditions concerning material presented in this document It is subject to re examination revision and possible cancellation This product was not ULC listed as of document revision Additional listings may be applicable contact your local Simplex product supplier for the latest status Listings and approvals under Simplex Time Recorder Co are the property of Tyco Safety Westminster Rev 5 12 2019 Series Battery Cabinet with Charger selection information color 2 External battery cabinet with charger cabinet with charger 120 VAC input 3 Battery selection reference ordered separately Ah sealed lead acid battery Ah sealed lead acid battery Ah sealed lead acid battery for each battery Quantity VDC 2081 9287 batteries fit in the 4010 cabinet but are also compatible with these battery cabinets reference 2 reference notes Cut conduit entrance holes as required Power limited and non power limited wiring must be in separate conduit AC power entrance is recommended at the bottom right of the cabinet Refer to Installation Instructions 574 199 2019 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without Additional listings may be applicable contact your local Simplex product supplier for the latest status Listings and approvals under Simplex Time Recorder Co and the product names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are trademarks of the National Fire Protection Association NFPA Rev 5 12 2019