Simplex ES System Accessories; 4100ES 4100U 4010ES Compatible External Cabinet Battery Cabinet with Charger, 4081 Series

System Accessories Compatible External Battery Cabinet with Charger 4081 Series ULC CSFM Listed FM MEA NYC battery cabinet with charger for use with Simplex model 4100U and 4010ES addressable fire alarm control panels For mounting and charging of sealed lead acid batteries up to 110 Ah ordered separately Enclosure is a surface mounted red cabinet that mounts close nippled the control panel cabinet within 20 ft 6 m and connected with Models are available for operation at 120 VAC or 220 230 240 VAC charger details Charger provides dual rate operation with temperature compensation dynamic battery testing to detect for low voltage or missing battery Battery voltage charger voltage and current and charger status are all to the control panel and available for display Earth fault detection and depleted battery cutout are selectable UL listed to Standard 864 ULC listed to Standard S527 4100ES 4100U and 4010ES fire alarm control panels batteries mounted within their enclosures For system applications additional battery backup these battery cabinets with battery accommodate batteries up to 110 Ah and control The control panel indicates status conditioned required battery cutout For ULC listed systems the low battery cutout disconnects the batteries when they reach low voltage cutoff selection 1 External battery cabinet with charger VAC Input input multi Compatible Battery Cabinet with for batteries up to 110 Ah 2 Accessories LED Power on Indicator Kit required for ULC mounts above access panel using knockout 3 Battery reference ordered separately per Ah Sealed Battery 12 VDC 1 4081 9306 4081 9308 4100ES 4100U 4010ES battery cabinet with charger 2 2081 9279 batteries two required 24 V system exact appearance may vary reference 4 Additional reference Instructions Reference Battery Data Cabinet without charger for to 110 Ah Batteries This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7165 0026 251 for allowable and or conditions concerning material presented in this document It is subject to re examination revision and possible cancellation 4081 9306 has been accepted for use City of New York of Buildings MEA35 93E UL and ULC fire alarm system requirements are satisfied when 2081 9279 batteries are used with these remote battery cabinets and chargers 2081 9279 are equipped with flame arrester vent caps in accordance with UL Standard 924 requirements Additional listings may be applicable contact your local Simplex product supplier for the latest Listings and approvals under Simplex Time Recorder Co are the property of SimplexGrinnell LP Westminster Rev 6 01 2020 Compatible External Battery Cabinet with Charger 4081 Series and charger specifications Type Type and Capacity Output Voltage Standby Current Requirement Output Protection 5 General specifications rate temperature compensated for batteries 55 Ah to 110 Ah Recharges batteries within 48 hours per UL Standard 864 and to 70 capacity in 12 per ULC Standard S527 lead acid Batteries are ordered separately VDC nominal mA A fast acting fuse Charger is reverse polarity protected VAC Input Models VAC Input Models Range Range Connections from Control Panel Hardware and Cables 6 Input power requirements to 132 VAC 60 Hz A maximum to 264 VAC 50 60 Hz separate taps for 220 230 240 VAC A maximum 7 Environmental and mechanical Input Output to 122 0 C to 50 C to 93 RH non condensing 100.4 F 38 C maximum block for 14 to 12 AWG block for 14 to 6 AWG wire 5 terminals each for and ft 6 m maximum in conduit and cables to connect to 2081 9279 110 Ah batteries communications harness ft long 6 m battery connection harness to power distribution module PDM wire equivalents 14 AWG 2.08 mm2 12 AWG 3.31 mm 6 AWG 13.3 mm2 2081 9279 Battery specifications Voltage dimension reference 8 Battery specifications Ah rating at 20 hour discharge rate V per battery 2 required for 24 V system current terminal posts in W x 9 in H x 10 1 2 in D 284 mm x 230 mm x 267 mm lbs 37 kg 3 dimension reference 2020 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without Additional listings may be applicable contact your local Simplex product supplier for the latest status Listings and approvals under Simplex Time Recorder Co and the product names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are trademarks of the National Fire Protection Association NFPA Rev 6 01 2020