Simplex EXI CPM-ID

SPECIFICATION CPM ID Number ARPCP01 IDO CPM ID is the heart of the local perimeter of egress location as well as name and number of patient when used in conjunction with APEX system The CPM ID generates a 300 KHz field which defines the door coverage area CPM ID also receives the transmitted ID of the entering the field at 312 MHz When a is detected in the field the CPM ID will 24V 320 mA for the maglock s as well as an auxiliary form C contact closure alarm is generated when a transponder enters the exciter field The receiver portion of the captures the receive signal and compares it to template stored in the microprocessor memory If received transmission from the transponder passes series of checks the CPM ID will trigger into alarm the information is discarded as noise Equipment Cable whip antenna switch and cable Controller AAPCT01 000 DataTerm Dataport Dedicated maglock drive signal Capability of two SEA exciter antennae for expanded contoured patterns alarm override and external alarm trigger Alarm Override input 200 mA regulated output ID available at Data output port Voltage Voltage aux Supply frequency Frequency Protocol cable length cable length 18 2 unshielded relay cable length Ga ID VDC 500 mA VDC 200mA VDC 320 mA see KHz MHz x 24 x 7.6 cm x 9.5 x 3 M 3000 inputs outputs Disable Switch release C Relay 2 ID output with Elevator only local remote when shorted nurse saver alarm supervisory Input integration The CPM ID will source 160 mA to the maglock when the 24V 320mA jumper is on J1 J2 is selected the CPM ID will supply 320mA the maglock however when J2 is selected the 12 VDC 200mA is not available The cumulative length of the data cable in an system network must not exceed 825M or 3000 of 18 AWG twisted unshielded cable Subject To Change Without Notice