Simplex EXI R2 Pak EI HALO, Networked

Model Number PAK EL SPECIFICATION Pak El HALO Networked R2 Pak El Networked is a HALO system with an interface incorporated into one steel cabinet to mounted on top of the elevator car The system detection field is totally contained within elevator car and travels with the car eliminating the for elevator lobby coverage on every floor thus the number of total systems needed This also contains the detection field to within the eliminating nuisance alarms from passers by in the lobby Two SEA E antennas and an elevator antenna are mounted in the elevator car and are in the R2 Pak El Networked Also included in package is a RIM for interfacing to the HALO communications network sound module shown at the right is within the elevator car above ceiling panel and will sound an 11 is detected in the elevator car Also mounted on the elevator control panel is a used for bypass If the keypad is activated before the 11 second pre alarm has ended the will go into bypass mode allowing normal elevator operation If the bypass keypad is activated the system will go into full alarm the loud buzzer in the sound module goes off the elevator doors will not close disabling the elevator until the transponder is removed the car A traveler cable may be installed carrying the patient ID and the zone location to HALO Console however the system is equally effective as a standalone unit as the elevator not move from the floor with a transponder on board Equipment Console AR2PC01 095 Tag warning when Number Module Voltage frequency Frequency EL DKX WP for specifications x 21 4 x 21 8 x 18 x 4 20W KHz MHz inputs outputs Data Status Override Disable C Relay 1 ID door status alarm input elevator disable integration on local building codes a qualified elevator technician must install or be present at the of an elevator system Please check your local codes before attempting to install an elevator Subject to Change Without Notice