Simplex EXI Roampak EL

Model Number EL Specification EL Roampak EL is a RoamAlert ID system with an interface incorporated into one steel cabinet to mounted on top of the elevator car The Roampak transponder detection field is totally contained the elevator car and travels with the car the need for elevator lobby coverage on floor thus reducing the number of total systems This feature also contains the detection field to the car eliminating nuisance alarms from by in the elevator lobby Two SEA E antennas an elevator receive antenna are mounted in the car and are included in the Roampak EL sound module Shown at the right is within the elevator car above ceiling panel and will sound an 11 is detected in the elevator Also mounted on the elevator panel is a keyswitch used for If the keyswitch is activated before the 11 second pre alarm has ended the elevator will into bypass mode allowing normal operation of the elevator If the bypass keyswitch is not the Roampak EL will go into full alarm the loud buzzer in the sound module goes off the elevator doors will not close disabling the elevator until the transponder is removed the car A traveler cable may be installed carrying the patient ID and the zone location to APEX Dataterm however the Roampak EL is equally effective as a standalone unit as the will not move from the floor with a transponder on board The bypass keyswitch can be to a DKX keypad Equipment Dataterm Cpntroller 6 Zone annunciator Digital bypass keypad Wrist Transponder warning when Number Module Voltage frequency Frequency EL x 2 x 11 4 mounting hole x 21 4 x 21 8 x 18 x 4 20W KHz MHz inputs outputs Status Override Disable C Relay 1 ID Door Status Alarm Input elevator disable integration Subject to Change Without Notice