Simplex External Battery Box Installation Instructions 4001-9809

4001 9809 External Battery Box power to control panel is OFF before proceeding the external battery box as follows Unlock and open battery box door Remove knockout plug on top or side of box for harness exit to fire alarm control panel Holes are provided on the rear of the box for securing it to the wall Battery box must be close nippled At battery box mounting box with batteries control panel with a protective metallic raceway maximum feet position box and secure with fasteners which are capable of weight w batteries 42 Ibs with batteries and box to control panel as follows existing battery cable with the control panel and connect external battery harness Place 18AH batteries mounted box See Figure 1 A harness provided extends the battery cabinet below You must run the harness the control panel and up to the control panel battery terminal TBI knockout the control panel Connections are a above Check all battery polarity REVERSED CONNECTIONS MAY EQUIPMENT Connect wire of battery harness black wire without connector connector TBl 4 See Figure 2 control panel TBl 3 Connect wire of battery harness connector positive terminal of one battery Connect wire of battery harness with connector negative of other battery See Figure 2 Do not connect white wire DAMAGE TO EQlJ PiENT DURING installation manual Pub No FA4 31 001 batter v terminals now BATTERY POWER MAY Refer to the system operating final power connections THROUGH KNOCKOUT THAT IS TO CONTROL 1 2 1966 Shplex Gardner Mass 01441 0001 3 86