Simplex Install Instructions 4100-0632 Terminal Block Utility Module

Terminal Block Utility Module Instructions Warnings AND SAVE THESE INSTRUCTIONS Follow the instructions in this installation manual These instructions be followed to avoid damage to this product and associated equipment Product operation and reliability depend proper installation NOT INSTALL ANY SIMPLEX PRODUCT THAT APPEARS DAMAGED Upon unpacking your Simplex inspect the contents of the carton for shipping damage If damage is apparent immediately file a claim with the and notify an authorized Simplex product supplier HAZARD Disconnect electrical field power when making any internal adjustments or repairs All should be performed by a representative or authorized agent of your local Simplex product supplier HAZARD Static electricity can damage components Handle as follows Ground yourself before opening or installing components Prior to installation keep components wrapped in anti static material at all times SAFETY HAZARD Under certain fiber optic application conditions the optical output of this device may exceed safety limits Do not use magnification such as a microscope or other focusing equipment when viewing the output this device publication describes the installation procedure for the 4100 0632 Terminal Block Utility The terminal block utility module is an all purpose terminal block that mounts to an bay above or below the power distribution interface PDI Each module utilizes one of mounting space terminal block utility module has two 16 position terminal blocks that accept up to a of 12 AWG wire product is compatible with 4100U and 4100ES Fire Alarm Control Panels FACP 2001 2011 SimplexGrinnell LP All rights reserved and other information shown were current as of publication and are subject to change without notice and the Simplex logo are trademarks of Tyco International Ltd and its affiliates and are used under license B Block Utility Module Installation Instructions to the Bay the directions below to mount the terminal block utility module to the electronics bay Align the terminal block utility module to any two compatible screwholes on the electronics There are eight possible locations four above and four below the PDI Refer to the figure Secure the terminal block utility module to the electronics bay with two 6 screws and washers number 441 002 1 Mounting the Terminal Block Utility Module B