Simplex Security Monitor IAM for 4100ES, 4100U, and 4010ES IDNet, Model 4090-9121

ULC CSFM Listed FM Approved NYC Acceptance Peripherals Security Monitor IAM Addressable Module use with Simplex 4100ES 4100U and Fire Alarm Control Panels providing communications communications supply both data power over a single wire pair to provide Supervised Class B monitoring of normally closed or open dry contact security devices Monitored conditions are Open Normal Abnormal Abnormal occurs with of monitor loop current Short Total wiring distance from Security IAM to contacts up to 500 ft 152 m sealed construction Enclosed design minimizes dust infiltration Mounts in a standard single gang electrical box Screw terminals for wiring connections Visible LED flashes to indicate communications Optional covers are available to allow LED to be after installation requires mounting bracket separately listed to Standard 1076 Monitor IAM model 4090 9121 has both power communications supplied by a two wire 4100ES or 4010ES IDNet circuit It provides location addressability for up to five initiating devices as window or door magnet switch contacts or other security devices by monitoring the circuit wiring to either normally closed or normally open contacts one type per IAM When the circuit is by selection the fire alarm control panel such as during hours monitor loop activity short open or causes a priority 2 alarm at the panel the circuit is such as during normal hours normal and abnormal conditions would be as events Depending on the point type selected open or short in the monitored circuit wiring will cause trouble to be reported or a short can be tracked as an This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing for allowable values and or conditions concerning material presented in document It is subject to re examination revision and possible cancellation listings may be applicable contact your local Simplex product supplier for the status Listings and approvals under Simplex Time Recorder Co are the property SimplexGrinell LP Westminster Security Monitor IAM approximately full size Selection Monitor IAM trim plate with LED viewing requires 4090 9810 mounting includes mounting screws steel mount bracket mounts IAM to box provides screw for trim plate required for optional trim plates k Resistor Harness use for series connection to N O k Resistor Harness use for end of line resistor connected to N O switches k Resistor Harness use for series and end of line when connected to N C switches 2 required IDNet one address two 2 unit loads power is supplied the IDNet SLC signaling line circuit Channel max on a 64 pt channel max on a 127 pt channel max on a 250 pt channel other on channel contacts up to 5 in series for normally closed or up to 5 in parallel for normally open requires two resistor harnesses per wiring selected see above Connections terminals for in out wiring to 14 AWG wire 0.82 mm2 to 2.08 mm2 to Contacts ft 152 m maximum within same building ft 762 m max distance from control panel ft 3048 m maximum total wiring distance T Taps W x 1 3 4 H x 1 1 4 D mm x 44 mm x 32 mm Material thermoplastic to 120 F 0 to 49 C indoor operation only Range to 93 RH at 100 F 38 C to Installation Instruction 574 877 IDNET IN IDNET IN firealarmresources com Mounting Information is a registered trademark of Tyco International Services GmbH and is used under license Simplex the Simplex logo and IDNet are trademarks of Tyco International Ltd and affiliates and are used under license LP Westminster Westminster MA 01441 0001 USA 2011 Tyco All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Trim Plates and Mounting Bracket for Visible LEDNOTE These mounting plates require mounting bracket 4090 9810 Mounting Reference Single Gang Blank Cover Plate IDNET IN IDNET IN Single gang electricalbox 2 1 2 64mm minimum depth supplied by others Single gang blank cover plate and mounting screws for use whenLED is not required to be externally viewed supplied by others 4090 9121Security IAMAddress setting under resealable labelLED viewing portTypical application magnetic door contactsField wiring shownfor reference4090 9806 Trim plate for semi flush mounted box4090 9807 Trim plate for surface mounted box4 1 4 108 mm 2 1 2 64 mm 2 13 16 72 mm 4 1 2 114 mm Light pipe forLED viewing4090 9810 Mountingbracket orderedseparatelyfirealarmresources com