Simplex Transient Suppressor-Zone Disconnect Boards 4001-9804 Transient Suppressor, 4001-9806 Zone Disconnect, & 4001-9807 Combination

BfSimplex Transient Suppressor Zone Disconnect and Combination Transient Disconnect Boards Ensure power the 4001 control is OFF before proceeding INDICATING APPLIANCE SEE STEP 2 board the control panel as shown 1 INITIATING DEVICE SEE 3 4 i electrical connections as follows Connect board ribbon cable harness to board control the blue marked Pl Connect connector Pl Ensure end lines up with pin 9 on each connector other end For the 4001 9804 appliance circuit 10 SIG suppressor board or TBl 9 For the 4001 9804 or 9807 board connect device circuits as indicated Table 1 any of the designated zone terminals on the do not have initiating devices connected them a 3.3K ohm EOLR must be connected those terminals BOARD 1 BOARD If using waterflow or sprinkler connect them as follows Connect water flow switch normally ooen to 5 ZON3 and TBl 6 Connect srxinkler switch TBl 8 NO WIRES ARE CONNECTED TO ZONE A 3.3 K ACROSS THOSE TERMINALS 1 1966 Simplex Recorder Gardner MISS 014414001