Simplex Wireless Clock Systems, GPS Synchronized Systems, 1-W Signal Transmitters and Accessories

Clock Systems Synchronized Systems Signal Transmitters and Accessories GPS synchronized time system signal Provides signal coverage for single buildings or smaller applications Available with internal or external antenna Available Satellite Transmitter provides additional where more than one transmitter is required Transmitter output is 1 Watt maximum measured at transmitting in the 72 MHz frequency range 16 channels are available pre programmed prior to to minimize interference potential Daylight saving time bypass switch Time zone adjustment switch pre programmed on antenna Model 14000E prior to shipping LCD readout provides time date and signal verification Transmitters and Satellite Receiver include UL Listed VAC to 9 VDC power supply transmitter details Requires installation of a Master Transmitter to receive transmit the GPS time signal Uses a Satellite Receiver Switch to synchronize with the Transmitter included with Satellite Transmitter Receiver Specifications Supplied accessories includes a 10 ft 3 m long cable with Primary Transmitter mounting bracket and hardware for rooftop or installation Additional cable lengths are available synchronized time system transmitters receive signals the GPS Receiver synchronizing it to the highly NIST Coordinated Universal Time National of Science and Technology Transmitters then broadcast the GPS synchronized time to system clocks at the 72 MHz range and preset to of 16 channels licensed by the FCC and IC to interference on these frequencies and channels availability of internal antenna transmitters external transmitters and satellite transmitters provides for coverage of a wide variety of applications to the following data sheets for Simplex GPS Wall Clocks receivers and accessories Sheet Series Clocks Dial Options Case Clocks Bell and Tone Synchronization and Clock Accessories Transmitter with Internal Antenna Transmitter with External Antenna Selection Description 1 Watt Transmitter Package includes GPS Receiver Model 14005 Mounting Rack and Model 14196 Protector Primary 1 Watt Transmitter with GPS Receiver Transmitter Package includes Satellite Receiver Switch Assembly 14005 Transmitter Mounting Rack 100 ft m of connection cable and Model 14196 Protector Satellite Transmitter with Satellite Receiver Antenna 1 Watt Transmitter includes requires selection of antenna mounting below Pole or Wall Mount Kit Non Penetrating Mast mounted Mounting select one Refer to accessories data sheet S1400 0006 for detailed on mounting rack UPS and additional cable Satellite Transmitter requires installation of a Primary and its associated GPS Receiver 8 2009 Installation Reference Antenna m mm Connection Reference Antenna Transmitter shown Transmitter Case mm 406 mm lug mm Conversion included supply with ft 1.8 m cord mm mm Receiver 2 1 2 dia x 3 4 64 mm x 19 mm with 5 ft m cord Receiver Reference mm mm ft long 1.5 m cable Specifications Specifications Supply Listed Output Input 120 VAC 50 60 Hz 0.4 A connects directly to wall outlet with Transmitters and Satellite Receiver Switch VDC 2 A 6 ft long cord 1.8 m F to 158 F 0 C to 70 C indoor mounting only for Transmitters GPS Receiver and Receiver Switch not applicable to external antenna Temperature Range Specifications Case Dimensions all with Internal Antenna with External Antenna diagram above for antenna Receiver Specifications included with primary transmitter wide x 12 deep x 1 7 8 high 406 mm x 305 mm x 48 mm is 46 high 1.2 m above case weight 7 3 4 lbs 3.5 kg Part 90 Accepted US IC RSS 119 Accepted Canada 100 ft 30 m of cable for antenna connection 9 lbs 4.1 kg diameter x 3 4 thick 64 mm x 19 mm weight 12 oz 0.34 kg brackets and hardware are included for pole mount with U clamp or window with suction cups Note Not for use through Low E glass ft 3 m cable is supplied additional cable extensions are available in the following 50 ft 15 m 100 ft 30 m 150 ft 46 m and 200 ft 61 m contact your Simplex supplier for details Receiver Switch Specifications included with Satellite Transmitter Dimensions Dimensions signals from the Primary Transmitter to synchronize the Satellite Transmitter wide x 4 1 4 high x 1 1 4 deep 146 mm x 108 mm x 32 mm ft 1.5 m long RS 232 cable high 318 mm built into case is a registered trademark of Tyco International Services GmbH and is used under license Simplex and the Simplex logo are trademarks of Tyco International Ltd and its and are used under license 2009 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA 8 2009