Symplex 4100U System Accessories; Remote Emergency Firefighter Telephones; AUTOCALL CommFone Upgrade

CSFM Listed NYC Acceptance existing AUTOCALL CommFone remote mounted phones to be compatible with 4100U firefighter phone systems Phone kits upgrade to 4100U firefighter phone features costly removal of the installed backbox Existing AUTOCALL CommFone wiring is used no wiring is required UL Listed to Standard 864 Please note that these phones are not compatible with CommFone 500 systems upgrade phone kits include Red phone with armored cable and sealed receiver and caps Red phone with armored cable sealed transmitter and caps and push to talk PTT switch Phone upgrade requires use of Simplex firefighter phones Simplex pluggable phones are directly compatible with Jack Station 976200 Phones are available in red with standard operation or PTT switch see page 2 for details Firefighter telephone systems feature Master telephone can simultaneously talk with up to 6 telephones and can be connected as an audio for broadcast messages Ring signal on remote firefighter telephone indicates that call request is initiated and a hold signal indicates that connected line has been deselected Telephone circuits are supervised for open and short too many telephones connected and the master is supervised for cord integrity Degraded mode allows remote telephones to remain to each other in the event of a loss Refer to data sheet S4100 0034 for details upgrade to 4100U Existing AUTOCALL fire control panels with CommFone firefighter telephone equipment can be upgraded to the of the Simplex 4100U fire alarm control panel by these phone upgrade kits The existing handsets replaced with new handsets and wired according to included detailed Installation Instructions 579 806 enclosures are maintained to allow a quick and upgrade Note These handsets hang the same as the AUTOCALL handsets with the cable end at the of the enclosure when the handset is on its cradle System Accessories Remote Emergency Firefighter Telephones CommFone Upgrade CommFone Upgrade Kit Handsets are standard or with push to talk switch on right Pluggable Phone Details complete conversion of the existing AUTOCALL system to 4100U operation Simplex pluggable phones are required if used by the Pluggable phone model 2084 9014 standard 2084 9024 PTT are directly compatible with the CommFone model 976200 jack stations Simplex firefighter remote phone information covered on data sheet S2084 0001 This product has been approved by the California State Fire Marshal CSFM pursuant to 13144.1 of the California Health and Safety Code See CSFM Listing 6912 0026 054 allowable values and or conditions concerning material presented in this document It is to re examination revision and possible cancellation Accepted for use City of New Department of Buildings MEA35 93E This product was not ULC listed or approved by as of document revision date Additional listings may be applicable contact your local product supplier for the latest status Listings and approvals under Simplex Time Co are the property of Tyco Safety Products Westminster 8 2007 AUTOCALL CommFone Remote Phone Upgrade Kits and Related Products CommFone Upgrade Kits for mounted phones Red phone with 24 long 610 mm armored cable and sealed and transmitter caps Red phone with 24 long 610 mm armored cable sealed and transmitter caps and push to talk PTT switch Pluggable Phones and End of Line Resistor Red pluggable phone Type 4590 E Red pluggable phone with push to talk switch Refer to Installation Instructions 579 806 for additional information Kits include phone assembly with wire leads terminated with spade lugs Simplex Pluggable Phone Reference End of line Resistor Harness 10 k 1 2 W ref 733 894 one required for each Class B phone circuit illustrations below Red Pluggable Firefighter Phone Red Pluggable Firefighter Phone Push to Talk Switch Simplex and the Simplex logo are trademarks of Tyco International Services AG or its affiliates in the U S and or other countries 2007 Tyco Safety Products Westminster All rights reserved All specifications and other information shown were current as of document revision date and are subject to change without notice Safety Products Westminster Westminster MA 01441 0001 USA 8 2007