Solidyne sLON-V1, V2 data sheet

TECH/DATA SHEET VAV Controller sLON-V1 and sLON-V2 VAV Controllers are LONMARK variable air volume These controllers provide pressure control for cooling and reheat They feature a built-in actuator with over- damper mounting, an integral velocity transducer, LED indication, support for an digital sensor, push-button manual mechanical position indication, and an easy- mechanical travel limit. They function in mode or as part of a LonWorks network the integral FTT-10 Free Topology transceiver. A direct connection to a Communication adapter and a PC with Software Tool software is necessary to download modify applications. Chart Inputs Outputs Type Floating/ denotes LONMARK VAV (Variable Air Volume) profile and profile version Cooling Series Fan Induction Parallel Fan None Staged Electric Time Reheat None Occupancy Satellite Corporation – www.solidyne.com sLON-V2x rev1 03/2005 items not provided) carton for damage. If damaged, notify carrier immediately. Inspect controllers for Return damaged products. must be a qualified technician Job wiring diagrams Tools: AM-340, T-25 Torx short arm key (L-shaped wrench), or T-25 Torx bit with 1/4 in. hex shank (for use with socket wrenches) 1/4 inch hex driver for travel adjustment screws Pliers for turning damper shafts Digital Volt-ohm meter (DVM) Drill and bits for mounting screw Static protection wrist strap Torque wrench (capable of measuring at least 32 in-lb (0.37 Kg-meters)) AM-135, 3/8 in. (9.5mm) to 1/2 in. (12.8mm) shaft adapter (optional) Class 2 power transformer supplying a nominal 24 Vac (20.4 to 30 Vac) with a minimum of 12 VA, 50/60 Hz per controller plus Digital Output (DO) loads. Each DO can be to 24 VA. In European Community, transformer must conform to EN 60742 Terminators: One sLON-T1 terminator required for free topologies Two sLON-T2 terminators required for bus topologies One #10 sheet metal screw 0.170 in.(17/100) I.D. FRPE polyethylene tubing or 0.125 in. (1/8) I.D. or 0.25 in. (1/4) tygon tubing for piping connections. Not more than five feet (1.52m) long. Electrical shock hazard! Disconnect power before installing or removing the Follow Static precautions when installing this equipment. Use copper conductors that are suitable for 167 (75 Make all connections according to electrical wiring diagram, national and local electrical Precautions charges damage electronic components. The microprocessor and associated circuitry extremely sensitive to static discharge. Use the following precautions when installing, or operating the system. Work in a static-free area. Discharge static electricity by touching a known, securely grounded object. Use a wrist strap connected to earth ground when handling the controller printed board. Communications Commission (FCC) equipment has been tested and found to comply with the limits for a Class B digital pursuant to Part 15 of the FCC Rules. These limits are designed to provide protection against harmful interference in residential installations. This generates, uses, and can radiate radio frequency energy and may cause harmful if not installed and used in accordance with the instructions. Even when are followed, there is no guarantee that interference will not occur in a particular If this equipment causes harmful interference to radio or television reception can be determined by turning the equipment off an