System Sensor ISO-6 Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Six Fault Isolator Module Operating Voltage: Current: Current Draw: Range: Gauge: 15-32 VDC 450 microA per circuit, 2.7 mA all circuits 17 mA per circuit in isolation, 102 mA with all circuits in isolation 32 to 120 (0 to 49 10 to 93% Non-condensing 6.8 5.8 1.0 BB-2 Cabinet; BB-6 Cabinet; CH-6 Chassis 12-18 AWG 1: CH-6 CHASSIS Ohio Avenue, St. Charles, Illinois 60174 FAX: 630-377-6495 INSTALLING information is included as a quick reference installation guide. If the will be installed in an existing operational system, inform the op- and local authority that the system will be temporarily out of service. the power to the control panel before installing the modules. This contains static sensitive components. Always ground yourself with a wrist strap before handling any circuits so that static charges are re- from the body. The housing cabinet should be metallic and suitably This manual should be left with the owner/user of this equipment. DESCRIPTION ISO-6 Six Fault Isolator Module provides six equivalent circuits that will a portion of the communications loop to continue operating when a circuit occurs on that loop. An amber LED indicator will blink in the state for each of the six inputs and will latch on during a short circuit The module will automatically restore the communications loop to condition when the short circuit is removed. INCLUDE: 1 x 4 Terminal Blocks 1 (32mm) Stand offs Machine Screws Nuts REQUIREMENTS ensure proper operation, this module shall be connected to a compatible panel only. The number of devices that may be installed between fault isolator will vary based on the types of devices on the loop. Contact your Alarm Panel manufacturer or refer to your device manual for the correct load ratings of individual devices. When added together, the sum of isolator load ratings of the devices between fault isolator modules should exceed 1. are descriptions of the ISO-6 mounting frameworks. There are two options for ISO-6 modules: Up to six ISO-6 modules can be installed on a CH-6 in a BB-6 cabinet One or two ISO-6 modules can be installed in a BB-2 cabinet CH-6 chassis is used to mount ISO-6 modules in a BB-6 cabinet. It accom- up to six ISO-6 modules in a single cabinet row three modules wide two modules deep. BB-2 cabinet has a built-in chassis that will accommodate one or two modules. 2: BB-2 CABINET front ISO-6 module positions of each chassis are offset below the rear module positions so that all of the status indicators are visible. BB-6 cabinet will house the CH-6 chassis with up to six ISO-6 modules on it. BB-2 cabinet houses one or two ISO-6 modules on the internal chassis that part of the cabinet. Refer to cabinet installation documents for dimensions. 6B: INSTALLATION OF ISO-6 MODULE IN FRONT CHASSIS POSI- 1: Insert the bottom edge of the ISO-6 module down into a front slot of chassis. 2: Carefully swing the upper edge of the board towards the back of the until it touches the 11/4 (31.75mm) standoffs installed on the module. 3: Align two 4-40 screws with the two standoffs and tighten. 4: Wire the modules according to the instructions in this manual. All wiring must conform to applicable local codes, ordinances, and Install module wiring in accordance with the job drawings and appropri- wiring diagrams. Make electrical connections by stripping approximately 1/4 (6.35mm) of from the end of the wire sliding the bare end of the wire under clamping plate, and tightening the clamping plate screw. All references to power limited represent Limited (Class 2) 7: WIRING AND PROGRAMMING THE ISO-6 MODULE PANEL PREVIOUS DEVICE LINE CIRCUIT VDC MAX. PAIR RECOMMENDED