System Sensor L-Series MP120KL Accessory (I56-0006)

INSTALLATION AND MAINTENANCE INSTRUCTIONS VAC Adapter Mounting Plate SPECIFICATIONS Operating Temperature: Range: Voltage: Voltage Range: Draw From AC Line: to 151 ( to 66 to 93% non-condensing (indoor products) 120 VAC VAC mA max. Ohio Avenue, St. Charles, Illinois 60174 FAX: 630/377-6495 may be used with any standard L-Series indoor Horn, Strobe, or Horn Strobe, at all horn and strobe settings. This manual shall be left with the owner/user of this equipment. DESCRIPTION MP120KL mounting plate is designed to allow the use of 120 VAC to L-Series indoor horn, strobes, horn strobes, chimes, and chime strobes. MP120KL consists of a mounting plate that has been fitted with a power that converts 120 VAC to nominal 24V FWR. MP120KL must be installed using a 120 VAC power source. This unit only be used for non-synchronous applications; it will NOT work with Sensor Sync Modules. module has pig-tail wires and is intended to be wired without rigid con- inside a standard electrical box. (WALL) Attach the mounting plate. (See Figure 2.) The mounting plate is compat- only with 4 4 electrical boxes. Connect field wiring. (For indoor models only) If the product is not to be installed at this point, use the protective dust to prevent contamination of the mounting plate terminals. To attach product to mounting plate: Remove the protective dust cover. Hook the tabs on the top of the product housing into the grooves on plate. Pivot the product into position to engage the terminals on the mount- plate. Make sure that the tabs on the back of the product housing engage with the mounting plate. Hold product in place with one hand, and secure product by tighten- the single mounting screw in the front of the product housing. 1. NON-SYNCHRONIZED DEVICES; ANY COMBINATION OF MODELS POWERED BY A 2-WIRE CIRCUIT Strobe Only VAC Wire System Mix of Models for Tandem 2. WALL-MOUNTING (INDOOR ONLY) BACKBOX WIRES MOUNTING PLATE mounted to MP120KL Module) WALL-MOUNT APPLIANCE (CEILING) L-Series ceiling appliances use a round mounting plate that is not sup- with the MP120KL. The mounting plate that ships with the notification will need to be attached to the MP120KL module Remove the mounting plate which comes attached to the MP120KL Disconnect the red and black wire and remove the 4 mounting that attach the mounting plate to the MP120KL module. Attach the round mounting plate that ships with the notification appli- to the MP120KL module. Attach with the four screws from Step 1 attach the red and black wires to the terminal screws. Attach the mounting plate. (See Figure 3.) The mounting plate is compat- only with 4 4 electrical boxes. Connect field wiring to the mounting plate per the notification appliance manual. If the product is not to be installed at this point, use the protective dust to prevent contamination of the mounting plate terminals. To attach product to mounting plate: Remove the protective dust cover. Hook the tabs on the top of the product housing into the grooves on plate. Pivot the product into position to engage the terminals on the mount- plate. Make sure that the tabs on the back of the product housing engage with the mounting plate. Hold product in place with one hand, and secure product by tighten- the single mounting screw in the front of the product housing. Models only: To remove product from the mounting plate, loosen the mounting screw and press the locking button. 3. CEILING-MOUNTING (INDOOR ONLY) WIRES MODULE plate removed) BACKBOX MOUNTING PLATE with Notification Appliance) CEILING-MOUNT APPLIANCE Sensor Strobes and Horn/Strobes have been tested and found to comply with the for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are to provide reasonable pro