System Sensor SAA Outdoor Ceiling Strobes _ Horn Strobes

Outdoor Selectable- Strobes and Strobes for Applications Advance outdoor audible visible products rich with features that cut installation times and profits. Weatherproof NEMA 4X, IP56 rated Listed to UL 1638 (strobe) and UL 464 (horn) Compatible with System Sensor synchronization protocol and SpectrAlert products Field-selectable candela settings: 15, 15/75, 30, 75, 95, 110, 115, 150, 177, and 185 candela Automatic selection of 12- or 24-volt operation at 15 and Rotary switch for horn tone and three volume selections Horn rated at 88+ dBA at 16 volts Rated from to 151 Universal mounting plate with an onboard shorting spring that wiring continuity before devices are installed Plug-in design with minimal intrusion into the back box Tamper-resistant construction Listed for ceiling or wall mounting Listings (chimes, horn strobes, horns) (outdoor and alert strobes) (outdoor strobes) (horn strobes, strobes) (horns, chimes) Advance offers the broadest line of outdoor horns, and horn strobes in the industry. With white or red plastic wall or ceiling mounting options, and plain or FIRE-printed SpectrAlert Advance can meet virtually any application including indoor, outdoor, wet, and dry applications in from to 151 the entire SpectrAlert Advance line, outdoor strobes and horn for ceiling applications include a variety of features that application flexibility and simplify installation. First, field- settings, including candela, automatic selection of 12- or operation, horn tones, and three volume options enable to easily adapt devices to meet requirements. SpectrAlert Advance devices use a universal mounting plate both wall and ceiling applications. This mounting plate includes onboard shorting spring that ensures wiring continuity before are installed, so installers can verify proper wiring without the devices and exposing them to potential construction Once the plates are mounted, all SpectrAlert Advance utilize a plug-in design with a single captured screw to installation and virtually eliminate costly ground faults. devices ship with weatherproof plastic back boxes (metal boxes are available separately) that accommodate in-and- wiring for daisy chaining devices. Plastic back boxes feature side flanges and improved resistance to saltwater Plastic and metal weatherproof back boxes come with top and bottom conduit entries and knock-outs at the Three screw-in NPT plugs with O-ring gaskets for a watertight is included with each back box. Advance Outdoor Strobe, and Horn Strobe Specifications Specifications Advance outdoor horns, strobes, and horn strobes shall mount to a weatherproof back box. A universal mounting plate shall used for mounting ceiling and wall products. The notification appliance circuit wiring shall terminate at the universal mounting plate. SpectrAlert Advance products, when used with the Sync Module accessory, shall be powered from a non-coded notification circuit output and shall operate on a nominal 12 or 24 volts. When used with the Sync Module, 12-volt-rated notification circuit outputs shall operate between 8.5 and 17.5 volts; 24-volt-rated notification appliance circuit outputs shall operate between and 33 volts. Outdoor SpectrAlert Advance products shall operate between and 151 degrees Fahrenheit from a regulated DC or full- rectified unfiltered power supply. Strobes and horn strobes shall have field-selectable candela settings including 15, 15/75, 30, 75, 95, 115, 135, 150, 177, and 185. strobe shall be a System Sensor SpectrAlert Advance Model _______ listed to UL 1638 and shall be approved for fire protective service. strobe shall be wired as a primary-signaling notification appliance and comply with the Americans with Disabilities Act requirements for signaling appliances, flashing at 1 Hz over the strobe entire operating voltage range. The strobe light shall consist of a xenon flash and associated lens/reflector system. The strobe must b