System Sensor Select Series Bases

Select Series Base Sensor mounting bases and kits provide a variety installation options for detectors in any application. Bases enable quick and secure detector plug-in SEMS screws provide easy wiring connection Support for 12-24 AWG provides installation flexibility Multiple base formats meet application requirements Standard white color with ivory and black options UL 268 compliant Mechanical locking feature restricts removal of attached sensor Base Features Pre-wired mounting plate simplifies installation Application driven feature sets Sounder bases both UL 268 and UL 464 compliant meet local code and application requirements, Sensor offers standard 4″ and 6″ bases, as well as, base designs including relay, isolator, sounder and low sounder options for Select Series detectors. standard 4″ and 6″ bases offer a plug-in detector base intended use in intelligent systems, with screw terminals provided for power and and remote annunciator connections. Communication place over the power (+ and lines. The 4″ base offers a design while the 6″ base provides compatibility with a wider of junction boxes. Select Series specialty bases support application driven The bases employ a separate mounting plate installs on various junction box sizes to eliminate unsightly boxes. The mounting plate enables pre-wiring of all to speed and simplify installation. bases (B224RB-WH/B224RB-IV) provide one form C contact for control of auxiliary functions, such as door closure and recall. The relay can operate in two different modes (short long delay). The activation time for the short delay is 60 ms to ms, while the activation time for the long delay is 6 sec to 10 sec. shunt with pin headers, located on the base PC board, is used to the delay timing. bases (B224BI-WH/B224BI-IV) allow the Signaling Line (SLC) loop to operate under fault conditions created from a circuit preventing an entire communication loop from being The base isolates the section of the loop containing the circuit from the remainder of the circuit and automatically when the fault is corrected. Select Series sounder and low frequency sounder bases designed for new and existing dwelling unit applications. offer maximum flexibility in installation, configuration, and to meet or exceed UL 268 and UL 464 requirements. The Listings & 6″ bases: 7300-1653:0109 & Isolator bases: 7300-1653:0126 bases: 7135-1653:0213 bases: 7300-1653:0238 Consult your fire alarm control panel manufacturer for compatibility the addressable model of the sounder base. 04/04/2018 Page 1 Series low frequency sounder bases designed to meet the NFPA 72 sleeping requirement to produce a fundamental of 520 Hz +/- 10% with a square or its equivalent. Studies show that a frequency, centered around 520 Hz, is most ideal to wake sleeping occupants, those with mild to severe hearing loss. B200SR sounder and LF sounder bases are fully compatible with B501BH-Series sounder base The device enables users to one of two B501-supported tones Temporal 3 or Continuous) through a B200S sounder and LF sounder bases adopt the same address as detector, but use a unique device type the loop. The Fire Alarm Control Panel can use that address to command individual sounder or a group of to activate. The command set the FACP can be tailored to multiple tone outputs allowing selection volume (75 or 85 dBA), tone (ANSI 3, ANSI Temporal 4 or March Time) group. In addition, some FACPs will custom tone patterns. The B200S sounder bases recognize the System synchronization protocol. This it to be used as a component of general evacuation signal along with System Sensor AV appliances when to a power supply or FACP output of generating the System Sensor pulses. Select Series Bases Specifications B50