System Sensor BEAMLRK Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Range Kit for use with Projected Beam Smoke Detectors This manual should be left with the owner user of this equipment 1 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 DESCRIPTION BEAMLRK allows reflected beam detectors to be installed at separations 230 and 328 feet 70 to 100 meters At these distances four 8 reflectors must be used to provide enough reflected infrared light This includes 3 additional reflectors with new test scale legends The reflector with the transmitter receiver unit is the fourth reflector to be used kit is not compatible with the multi mount kit BEAMMMK kit includes the following parts Description 8 reflector 10 to 25 test scale 8 reflector 30 to 65 test scale 8 reflector no test scale INSTRUCTIONS Peel off the test scale sticker from the reflector included with the trans unit Securely mount all four reflectors to the wall using all four screw holes each reflector see Mounting Instructions section of the manual in with the transmitter receiver unit for more details The reflectors be mounted as close to each other as possible They should be in a square pattern as indicated in Figure 1 The upper left when viewed from the front should contain the lower test scale to 25 The upper right reflector should contain the higher test 30 to 65 The bottom reflectors do not have a scale on them Complete the installation of the transmitter receiver unit using the in included with the beam detector Test the system as indicated in the beam detector instructions see Testing section of the transmitter receiver instructions System Sensor 06 10