System Sensor CO1224 Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Monoxide Detector Specifications This manual shall be left with the owner user of This product is intended for use in ordinary indoor Description Listed 4 Local Low Alarm Trouble Dual Test Hush SEMS Mount Optional 1 Alarm Location Diagram MONOXIDE ALARM FOR MULTI LEVEL RESIDENCE Specifications RH 1 Detector Operation Modes the detector has been in alarm for 30 minutes the alarm feature minutes by pushing the button marked The red light will continue to flash in temp 4 pattern If carbon feature of Life Timer feature When the detector has reached the CO sensor inside the detector has passed the end of its life must be replaced This detector lifespan is approximately UL 2075 it is mandatory that a trouble signal be sent to the upon CO cell trouble or cell end of life Refer to Figure 4 wiring of the trouble relay Guidelines Within Inside On Ideally If room the detector should be placed just outside the place Do not put wires more than 2 gauge apart under the This product does not have a local audible trouble diagrams located on page 4 Figure 4 Detectors operate best if not installed within 10 feet of any Directly Next Outside Do In Where Where Where 2 Mounting of Detector Using a small flat head screw driver push in the small tab on the underside of the detector Once the snap is Wire 4 Screw the base of the detector onto a single gang electrical Hinge Push After all detectors have been installed apply power to the Test Notify monoxide detectors are not to be used with detector unless the combination has been evaluated and found Before testing notify the proper authorities that mainte A 3 Use If Installation Guidelines carbon monoxide detectors to the alarm control panel and