System Sensor DH100ACDCLWP Manual

I AND MAINTENANCE INSTRUCTIONS Watertight Air Duct Smoke with Extended Air Speed Range Innovair DH100ACDCLWP is a photoelectric extended air range duct smoke detector with a NEMA 4 Rated water DH100ACDCLWP is listed for an extended air speed range of to 4000 feet per minute 0.5 m s to 20.2 m s NOTES and handling of must be observed product temperature 32 to 131 0 to 55 maintain the watertight properties of this duct smoke detector Installing thoroughly read the System Sensor Guide for Proper Use Smoke Detectors in Duct Applications This manual shall be left with the owner user of This detector must be tested regularly following 90 requirements The detector should be cleaned at least of Contents 1 1 2 2 4 7 7 8 8 General Description to the entire building Smoke detectors designed for air handling systems etc These actions can facilitate the and other auxiliary functions Auxiliary relays are also or by the optional remote test station The duct smoke installation the green LED should be flashing indicating the reset button on the front cover the control panel remote reset accessory The DH100ACDCLWP incorporates cover tamper feature that provides a trouble signal after 7 if the cover is removed or improperly installed Limitations Of Duct Smoke Detectors National Fire Protection Association has established that Sensor supports this position and strongly recom that the user read NFPA Standards 90A 72 and 101 DH100ACDCLWP Air Duct Smoke Detectors are listed per listed in this manual Failure to comply with these re Figure 1 Exploded View Of Duct Smoke Detector Components 2 Installation of foam gaskets over sampling bushings Contents Of The Duct Smoke Detector Kit Complete Two Two One Drilling Two One One One For ducts over 11 feet longer sampling tubes must be to complete the installation They must be the correct Installation Sequence Verify Duct Air Flow Direction And Velocity Select Mounting Orientation possible mount the DH100ACDCLWP with the wiring entry facing downwards so that all wiring enters the hous Drill The Mounting Holes Secure The Detector Housing To The Duct Do not overtighten the screws