System Sensor FTX-P1 Manual

AND MAINTENANCE INSTRUCTIONS Filtrex Intelligent Smoke Detector Installing the requirements of the Authority Having Jurisdic AHJ Detectors offer maximum performance when in compliance with the National Fire Protection Description uses a small air intake fan and a high density re sensing chamber while airborne particulate and water analog representation of smoke density over a commu smoke detector is intended for use in normal en conditions where dust and other airborne are present at elevated levels These elevated tend to cause false alarms and high maintenance standard detectors Filtrex provides a protective en for a photoelectric smoke detector chamber and smoke detection in areas that tended to use exclu heat detection requires compatible addressable communications function properly Connect this detector to listed com control panels only Sensor recommends spacing detectors in com with NFPA 72 In low air flow applications with applications refer to NFPA 72 or the System Sensor For Proper Use of System Smoke Detectors 1 Wiring diagram 4 S Instructions of the Authority Having Jurisdiction Proper color coded to limit wiring mistakes and ease system Improper connections will prevent a sys wiring must conform to applicable local codes ordi Wire Set Insert 5 wire connector on mounting base into 5 pin on Filtrex unit Install the detector into the After Test Jurisdiction AHJ Detectors offer maximum per Functional Magnet Test P N M02 04 01 or M02 09 00 This Smoke Entry Aerosol Generator Aerosol Scientific Following the manufacturer instruc 2 Rotary decade address switches 0 0 3 Test magnet position MAGNET 4 Replacing the filter cover is keyed to fit 4 matching slots marks are on the cap top of the filter the detector still fails any test have its filter replaced detector cleaning The only maintenance necessary is Filtrex in its installed location it is recommended that Install Connect Maintain a record for at least 90 days of any mainte At schedule maintenance Filtrex detectors should be the Filter air into Filtrex power is automatically cut from detector sending a trouble signal to the fire control