System Sensor IMPORTANT ASSEMBLY INFORMATION L-Series Speakers and Speaker Strobes Manual

ASSEMBLY INFORMATION Audible Visible Products and Speaker Strobes addition to the installation practices documented in the installation manual I56 0002 001 the following steps should be taken to insure installation of speaker and speaker strobe products 3 WIRE ROUTING SIDE VIEW INSTALL ELECTRICAL BOX Ensure the electrical box is flush or slightly recessed offset from drywall If the electrical box protrudes adjust the position of box To avoid a cosmetic gap between the device and ceiling the back box flush to slightly recessed with the ceiling drop ceiling installations make sure the electrical box is flush the ceiling tile 1 JUDGING DEPTH OF BACK BOX Orientation Orientation Orientation Shown Orientation Shown 4 WIRE ROUTING FRONT VIEW Check the depth of the box after mounting If the mounted is not flush with the mounting surface the device will not be against the mounting surface causing a cosmetic gap between product and the ceiling or wall ENSURE PROPER WIRE LENGTH AND WIRE ROUTING Ensure proper wire length and routing per the diagrams below that the wiring does not interfere with the product by pushing the back of the product The wires should be dressed to the to not interfere with the product The product should not be to push the wires back into the back box 2 MEASURING WIRE LENGTH WALL CEILING Length Length Orientation Orientation Entry 15.24 cm 10.16 cm 7.62 cm 12.7 cm 22.86 cm 15.24 cm 15.24 cm 20.32 cm wires to the sides the box so they don with the speaker terminating the wires wires down so they don with the speaker INSTALL MOUNTING PLATE When securing the mounting plate to the electrical box or back do not over tighten mounting plate screws 5 MOUNTING SCREW LOCATIONS 6 ATTACHING DEVICE CEILING VERSION SHOWN Mounting plate offers four locations for flexibility in choice of box If possible use all mounting screw holes on the selected box or back box Use only the screws provided with the Check that the mounting plate is flush with the wall as in Step 1 so that the final installation will also be flush the wall A0536 01 Screw SECURE THE DEVICE TO THE MOUNTING PLATE To provide proper electrical connections the appliance must be seated on the mounting plate and the product mounting on the front of the device must be securely fastened Optional If the captive screw is to be replaced with a tamper screw provided do that now PERFORM REQUIRED SYSTEM TESTS In accordance with NFPA 72 standards the system should be functionally tested prior to use Use the Feature There are two tabs at the top of the back side These match up with slots at the top of the plate Hold the device at about 45 to the mounting to align the tabs with the slots Slide the device tabs into slots so the device can pivot Carefully rotate the device into place against the mounting while checking the clearance between wires and the of the device If wires are routed as described in Step 2 product will rotate against the mounting place without The device should be seated flush on the mounting plate Fasten the product mounting screw on the front of the device hand tightening Stop when it is secure Note Over tightening may strip the screw connection If the cannot be fully tightened check the wiring to make sure it not interfering with the product See Figures 3 and 4 If the strips the mounting plate discontinue use of this product replace with a new product Note If there is a cosmetic gap between the product and the ceil the back box can be adjusted to be flush or slightly recessed the ceiling and the wires dressed to not interfere with the of the product See Step 1 and Step 2 System Sensor 08 18 2017 Sensor is a registered trademark of Honeywell International Inc firealarmresources com