System Sensor M500DM EngSpec

Product Dual Input Monitor Module and Engineering Specifications dual input monitor module shall be a System Sensor model number M500DM dual input monitor modules shall connect two supervised initiating device circuit or zones of conventional alarm initiating devices any normally open dry contact device to fire alarm control panel signaling line circuit SLC Loop Module shall have ability to uniquely an open circuit modules shall provide address setting means on the module using rotary switches Because the possibility of installation error systems that use binary jumpers or DIP switches to set the address are not acceptable The modules shall also store an internal identifying code the control panel shall use to identify the type of module Systems that require a special to set the module address including temporary connection at the panel are labor and not acceptable Each module occupies any one of at least 99 possible addresses the SLC loop It responds to regular polls from the system and reports its type and status module shall have an LED that is controlled by the panel to indicate module status Coded transmitted from the panel can cause the LED to blink latch on or latch off Refer to the panel technical documentation for module LED status operation module shall mount in a standard 4 inch square 2 1 8 deep electrical box or to a surface backbox The IDCs zones shall be wired for Style B Class B operation only The will use SEMS screws for easy wiring Wiring terminals shall be easily accessible for while installed UL 864 Control Units and Accessories for Fire Alarm Systems Agency Standards ULC S527 Control Units for Fire Alarm Systems ANSI NFPA 72 National Fire Alarm Code 2009