System Sensor M500R EngSpec

Product Relay Module and Engineering Specifications relay module shall be a System Sensor model number M500R Addressable relay shall allow a compatible control panel to switch discrete contacts by code command relay module shall provide two isolated sets of Form C contacts which operate as a double double throw switch The module shall allow the control panel to switch these contacts on The module shall not provide supervision for the notification appliance circuit NAC shall have both normally open and normally closed connections available for field wiring modules shall provide address setting means on the module using rotary switches Because the possibility of installation error systems that use binary jumpers or dipswitches to set the address are not acceptable The modules shall also store an internal identifying code the control panel shall use to identify the type of module Systems that require a special to set the module address including temporary connection at the panel are labor and not acceptable Each module occupies any one of at least 99 possible addresses the SLC loop It responds to regular polls from the system and reports its type and status module shall have an LED that is controlled by the panel to indicate module status Coded transmitted from the panel can cause the LED to blink latch on or latch off Refer to the panel technical documentation for module LED status operation module shall mount in a standard 4 inch square 2 1 8 deep electrical box or to a surface backbox The relay module contact ratings shall support up to 1 amp 30 VDC of load or 2 amps 30VDC coded of resistive load up to 3 amps in non coded The relay coil shall be magnetically latched to minimize wiring connection and to ensure that 100 of all auxiliary relays may be energized simultaneously on same pair of wires The module will use SEMS screws for easy wiring Wiring terminals shall easily accessible for troubleshooting while installed UL 864 Control Units and Accessories for Fire Alarm Systems Agency Standards ULC S527 Control Units for Fire Alarm Systems ANSI NFPA 72 National Fire Alarm Code 2009