System Sensor PR-1 Manual

I 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 AND MAINTENANCE INSTRUCTIONS Relay Voltage Current Temperature Range Temperature Range Length Ratings VDC 18 35 VAC 120 VAC mA max to 158 to 70 to 185 to 85 to 93 RH non condensing min 203 mm x 2.01 x 1.42 mm H x 51 mm W x 36 mm D wire nuts piece of double sided tape 11 4 screw VDC VAC 7A max 0.35 PF VAC 10A max resistive load max resistive load VDC This manual should be left with the owner user of equipment Description PR 1 is an epoxy encapsulated single pull double throw relay The PR 1 also uses a red LED as a visible indication relay coil energization ease of installation the PR 1 relay may be mounted in a va of ways It can be attached within compatible equipment in a separate enclosure using a mounting screw Double sided is also provided for additional support All wiring must conform to applicable local codes ordi and regulations PR 1 connections are shown on the label on the side of the Using the enclosed wire nuts secure the electrical connec appropriate to the application Provisions must be taken to power limited and non power limited wiring per National Code requirements Field installable wiring connected the product must have a minimum 1 4 inch spacing between power limited and non power limited wire There is high voltage running through the red wire To prevent injury put a wire nut on the red wire before install This is only applicable when using 120 VAC operating voltage wire DEFINITIONS INPUT 24 VDC 24 VAC INPUT 120 VAC COMMON NORMALLY CLOSED NORMALLY OPEN INPUT 24 VDC VAC 120 VAC Wire Wire Wire Wire Wire Wire LIMITED WARRANTY Sensor warrants its enclosed product to be free from defects in and workmanship under normal use and service for a period three years from date of manufacture System Sensor makes no other warranty for the enclosed product No agent representative or employee of the Company has the authority to increase or alter obligations or limitations of this Warranty The Company obligation this Warranty shall be limited to the replacement of any part of the which is found to be defective in materials or workmanship under use and service during the three year period commencing with date of manufacture After phoning System Sensor toll free number 736 7672 for a Return Authorization number send defec units postage prepaid to Honeywell 12220 Rojas Drive Suite 700 El TX 79936 USA Please include a note describing the malfunction and cause of failure The Company shall not be obligated to replace which are found to be defective because of damage unreasonable modifications or alterations occurring after the date of manufacture no case shall the Company be liable for any consequential or incidental for breach of this or any other Warranty expressed or implied even if the loss or damage is caused by the Company or fault Some states do not allow the exclusion or limita of incidental or consequential damages so the above limitation or may not apply to you This Warranty gives you specific legal and you may also have other rights which vary from state to state System Sensor 06 10