System Sensor SA SP3R1224MC and SP3W1224MC Manual

INSTALLATION AND MAINTENANCE Selectable Output Series Speaker Strobes for Protective Signaling Systems Speaker 12 DC FWR and 10 candelas are selectable Description the requirements of most agencies governing these including NFPA ADA The National Fire Alarm Having Jurisdiction for other codes or standards that amplifiers having an output voltage of either power supplies The strobes can also be installed output levels are established at Underwriters in their reverberant room Always use for Strobes The SP3 Series is suitable for dry and damp Supply Considerations For Strobes typically supply DC filtered voltage or FWR full are based on using the device current found Sizes Approximately Approximately Approximately Approximately only 2 volts drop The same devices using 18 AWG wiring must be installed in compliance with the Na using the proper wire size This also includes all NFPA Standards ANSI UL 1480 UL 1971 and Connect mind that even though the speaker and strobe are Do NOT loop electrical wiring under terminal Wires connecting the device to the control panel 1 Electrical connections FROM NEXT OR EOL FROM SUPPLY NEXT OR EOL See 2 Speaker Voltage and Power Selection 1 Sound levels for each transformer power tap 10 ft 2 Strobe current draw measurements 12 24 Volt applications Operating RMS Operatng RMS No Selections 3 For strobe candela selections adjust slide located on the rear of the product while the viewing window on the side of the Plug