System Sensor SMB600 Manual

INSTALLATION AND MAINTENANCE INSTRUCTIONS Surface Mounting Kit for Use with or 500 Series Detectors with Dia Base 400 Series Detectors and Sounder Bases DESCRIPTION SMB600 Surface Mounting Kit allows System Sensor to be surface mounted when the junction box to be used is not of adequate size 1 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 RIBS 2 RIB OFF 4 kit consists of the following parts surface mount base x 1 sheet metal screws x 1 anchors screws BOX MOUNTING INSTRUCTIONS Read and follow the installation instructions appropriate the detector head or other device to be used with SMB600 Pull the wires through the 1.3 dia hole in the of the base The SMB600 must be mounted to a listed junction box see Figure 3 Using the two 8 32 screws supplied mount the 6 dia mounting base direct wire mounting bracket or sounder base to the surface mount base When using the B402 B404 or B406 with the mount base the 4 alignment ribs Figure 1 must be cut off flush or below top edge of the surface mount base Figure 2 Wire the 6 dia mounting base or detector installation instructions 3 Mount the base using the supplied screws in the Surface Mounting Adaptor Kit When using the B402 B404 or B406 with the sur mount base the 4 alignment ribs see Figure must be cut off flush or below the top edge of surface mount base see Figure 2 Plug the detector head into its mounting base and rotate Test the system as indicated in the detector instruction WIRING MOUNTING INSTRUCTIONS Read the installation instructions appropriate for the head to be used and determine the number of used Drill out the appropriate holes using the drill centers on the sides of the adaptor see Figure 4 not use conduit larger than 1 2 to connect to the Mount the adaptor on the ceiling using the 2 keyholes appropriate screws or bolts not included The or bolts must be long enough to go through the 5 32 or 4mm and still fasten securely to the Pull wiring and conduit through the drilled hole s Attach not included to conduit fitting and tighten Wire detector base using the instructions included with base 4 DRILL CENTERS 4 System Sensor 06 10