System Sensor SSK451 Manual

I AND MAINTENANCE INSTRUCTIONS Multi Signaling Accessory Requirements 12.2 Information System Sensor SSK451 multi signaling accessory is for use with System Sensor DH100ACDC and optional PS24LO strobe can be easily added to the Hardware Kit contains 4 mounting screws the SSK451 as shown in Figure 1 for DH100ACDC 2 detectors Limit wire runs to 25 ohms or less per Coil Installation detector a test coil part number COIL400 must ordered separately When the SSK451 is used with a COIL400 is installed in the DH400ACDC duct smoke 3 1 SSK451 with DH100ACDC Duct Smoke Detector INSTALLED FOR PATTERN SELECT SIGNAL SIGNAL 3 SUPERVISORY CONTACT ALARM SIGNAL 3 2 RESET TEST 20 AUX POWER AUX POWER Wiring shown is for 4 wire smoke detector equipped a control panel 2 SSK451 with DH400ACDC Duct Smoke Detector DH100 ACDC INSTALLED INSTALLED FOR PATTERN SELECT SIGNAL SIGNAL 3 SUPERVISORY CONTACT 5 ALARM SIGNAL 10 3 RESET 4 TEST 6 AUX POWER 7 AUX POWER Wiring shown is for 4 wire smoke detector equipped a control panel DH400 ACDC INSTALLED 3 Test Coil Installation COIL SMOKE Strobe Lens follow the instructions enclosed with the lens for is missing The red LED is displayed and Function Indication Function Sounder SSK451 accessory provides the option of sounding a of the Optional Add On PS24LO Strobe optional strobe can be purchased separately and is 4 TERMINAL TOP the left hand side of the SSK451 Place one mounting Information Duct Smoke Detectors 4 Wire Accessories sounder or sounder strobe combination will not operate if power is cut off for any reason sounder may not be heard The loudness of the sounder or exceeds the current Underwriters Laboratories stan