System Sensor XR2B Manual

OPERATING INSTRUCTIONS Detector Installation Removal for use with System Sensor Profile Intelligent Detectors Description XR2B Detector Installation Removal Tool is designed use with System Sensor low profile intelligent detectors includes photoelectric photoelectric with heat ion and heat detectors This installation removal tool not work with the laser detector This tool permits and removal of detectors in elevated mounting up to 15 feet 4.6 meters high when it is used XP 4 extension poles ordered separately Assembly And Disassembly XR2B installation removal tool consists of a head as and connecting tube that is used with a set of XP 4 poles sold separately see Figure 1 assemble the tool attach the head assembly to one of XP 4 extension poles by sliding the small end of the top pole into the coupler end of the head assembly hole near the end of the tube on the head assembly fits the button of the extension pole to lock the head as to the extension pole The extension poles lock to other in the same way disassemble depress the lock button until the head as can be disengaged from the extension poles The poles can be separated from each other in the manner Installation install a System Sensor low profile intelligent detector a low profile base Insert and rotate the detector head into the installation 3825 Ohio Avenue St Charles Illinois 60174 FAX 630 377 6495 removal tool until the detector head bottoms and into place Raise the tool to the ceiling until the detector head enters mounting base and the locking ears on the detector meet the ring inside the mounting base Rotate the tool clockwise until the locking ears enter respective slots Continue rotating the tool until the detector is fully en in the base When this happens the detector can be rotated any further Carefully pull the tool from the detector head Removal remove a System Sensor low profile intelligent detector from a base Raise the installation removal tool to ceiling height lo the tool over the detector and push up and rotate the tool snaps onto the detector head Rotate the tool counterclockwise until the detector dis from the mounting base Lower the tool slowly and make certain that the detector is disengaged completely Continue lowering the tool When the detector head is at level the detector can be removed from the tool for testing or cleaning bases have a built in tamper resist feature that if must be disabled before the removal tool can be See the instruction sheet packed with the detector for instructions on disabling the tamper resist feature 1 XR2B Detector Installation Removal Tool and XP 4 Extension Pole 1 I56 2248 00 2 Insertion of detector head cup of XR2B Testing attach the magnet to the pole Pull the connecting pin and remove the Installation head from the pole assembly Push and hold the lock button and remove the con tube from the pole Remount the other end of the connecting tube to the making sure that the lock button snaps into place Slide the magnet into the slots and cover with the plastic Test The Detector Hold the test magnet near the raised mark on the smoke in one of the test areas shown in Figure 3 If the smoke detector does not alarm after 20 sec move the magnet to the other test area and Smoke detector LEDs should light and panel should in Push the reset button on the panel to reset the smoke See the smoke detector manual for additonal infor alarm using the XR2B removal tool with the XP 4 extension avoid any contact with overhead wiring The wood in the extension poles are not effective in all hazard situations 3 Test Magnet Position Test Magnet Status Test Magnet 2 I56 2248 00 2003 System Sensor