Valcom Digital Feedback Eliminator

PagePac 2 FEEDBACK ELIMINATOR V-5335611 is designed to eliminate acoustic When a page is made, the message is and saved. Upon completion of the live the message is released for broadcast over speakers. (While this page is being another page can be recorded). This the offensive squeal of feedback com- produced by telephones or microphones making a page. Comes with Power Supply Automatic Gain Control (AGC) Adjustable VOX Sensitivity Two Input Channels: selectable for primary and priority or dual with equal priority inputs are switch selectable for loop start Ohms) or VOX activation Two Audio Outputs: Out (600 Ohms) to Page Controller Level (8 Ohms) to Amplified Speakers or Background Music Input (adjustable) Three Normally Open Output Relays: Record, Busy Four LED Indicators: Power On, Play, Record, Busy Dip Switch Programmable Message Cancelling Easy to install in new or existing systems Solid State, DSP Storage and Playback High Fidelity CD Quality Sound Reproduction Loop Start Trunk Port of PBX C. O. Line Position of Key System Page Port Line Level Audio Feed Specifications Ohms Impedance: dBm Level: Ohms Out Output Impedance: Ohms Level Output Impedance: dBm (nominal) Level: Sensitivity: dBm to -35 dBm time after last sensed audio: 3 seconds duration of recorded page:60 seconds number of stored pages: Primary/Priority Mode Call Stacker Mode Response: Music: Hz to 7 kHz Hz to 17 kHz Power Requirements 500mA, Battery 10.3″H x 7.8″W x 2.2″D x19.8cm x 5.6cm) 2.6 lbs. (1.2 kg) Temperature: Humidity: to 40 (32 to 104 to 85% Manuals Online! – Manuals Online! – Notice equipment has been tested and found to with the limits for Class A digital devices, to Part 15 of FCC Rules. These limits designed to provide reasonable protection harmful interference when the equipment operated in a commercial environment. This generates, uses, and can radiate radio energy and, if not installed and used in with the instruction manual, may harmful interference to radio communica- Operation of this equipment in a residential is likely to cause harmful interference in case the user will be required to correct the at his own expense. is recommended that Category 3 or 5 twisted telephone wire be used for all wiring connec- to the V-5335611. A screw type connector is provided to allow connection of all wiring to V-5335611. V-5335611 is wall mountable using Connection Access Remove the small right side panel to all controls and terminations. To remove loosen the two screws holding the panel in and lift panel away from the board. Input level or low level source. Do not connect to or Voice-Coil audio output. Program Dip Switches are controls and switches on the board for the options of the V-5335611. Refer Figure 1 (page 5) for location of switches and or Call Stacker Line 1 Input primary input is the path normally used to the unit for recording and playback of a Method Settings Start Trunk Port System C.O. Line Key Alone Telephone Set Port w/Contact Closure Port w/o Cont. Closure Page Ctrl. Output (PagePal) Output C.C. ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON or Call Stacker Line 2 Input access will override primary input activity. Method Settings Start Trunk Port System C.O. Line Key Alone Telephone Set Port w/Contact Closure Port w/o Cont. Closure Page Ctrl. Output (PagePal) Output C.C. ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF