Valcom Multi-Tone Generator

PagePac 1 GENERATOR Multi-Tone Generator (MTG) is a compact, versatile generator as well as a Night Bell for a Telephone Six different information tones plus Night Bell are each of which are priority sensitive and individually The Multi-Tone Generator utilizes most paging for all page/all call applications. If the host telephone system does not have a page then a Loop Start Trunk Adapter can be used from the J2 connector to the Loop Start Trunk. Night bell activation by a ringing voltage and/or AC or DC voltages 6 information tones initiated by contact closures Compatible with most paging equipment Tone level adjustment Quick installation with keyboard style terminal strip and modular jacks Interfaces to mechanical or electronic time clocks for 7 sec. tone/alarm Comes with its own 12 VAC power supply that plugs into any 120 VAC, 60 Hz outlet CSA/NRTL Certified Desk, Shelf or Wall mountable 5.5 x 4.5 x 2.0 x 11.4cm x 5.1cm) 2.0 lbs (0.9 kg) Temperature: Humidity: to 50 (14 to 104 to 95% Requirements Nominal 12VAC at 60 Hz. The AC power is provided by a 12 VAC wall plug type external transformer, with the MTG. The AC input power may vary from 95V to 1130V at the wall plug. MTG is CSA/NTRL certified. Manuals Online! – Manuals Online! – Multi-Tone Generator produces five different tones by contact closure. The sixth tone (time clock port) is activated by making, or breaking contacts (see Table 1). Requested tones are switched as by the appropriate contact closure onto the paging audio path and provides a contact closure turn on the connected paging equipment for the duration of the tone request. J5 LEVEL IN OUT 1. Rear View of Multi-Tone Generator 1. Audio Information Tone Siren Siren changes in frequency from 560 Hz to 1050 and back, at a rate of 5 times per second. changes in frequency from 560 Hz to 1050 and back, at a rate of once every 3 seconds. Warble changes in frequency from 560 Hz to 1050 at a rate of 2 times per second. Pulse frequency of 500 Hz, interrupted 5 times per for a period of 30 milliseconds. Tone steady tone with a frequency of 680 Hz. Pulse pulses (same as priority 4) for a duration of 7 upon receipt of an external closing or contact. Bell between a frequency of 800 Hz and 1200 at a rate of 20 times per second. Signal An audio input signal. PIN 10 PIN 9 PIN 8 PIN 7 PIN 6 PIN 5 PIN 1 3 Manuals Online! – Manuals Online! – Bell Functions MTG Night Bell function is activated through J1, Pins 1, 2 and 3 connector (Night Bell). If the signal is a nominal 70 Vac, 20 cycle ringer voltage use Pins 2 & 3. The night bell can also be by a key system generating 10 to 30 volts AC at 60 cycles or it can be driven by 24 to 48 Vdc, polarity on Pins 1 & 2. customer owned phone system audio and control lines are attached to J2 (Page Input) and are unchanged through the MTG to J3 (Page/Tone Output) when it is in the inactive, (Tones/Night Off) state. This mode is referred to as Through The MTG, when accessed, will disconnect from J3 and connect the MTG audio and control lines to J3. 2. Connectors and Pin Identification J1. 10 Pin connector. J2, J3, J4 and J5. Quad RJ11 type connectors. 10 9 8 7 6 5 4 3 2