Valcom PagePac Amplicenters100w

PagePac 2 Plus AmpliCenter and Use Manuals Online! – Manuals Online! – Steps If installed next to other including the Plus Controller and Expansion Units, leave least four inches space and below for proper Mount the PagePac Plus AmpliCenter to either the wall 1), cabinet, or a 19 inch rack (Figure 2). VIEW – 120 VAC – 240 VAC – 60 Hz 1. Wall Mounted Hardware DETAIL PlusR D300 PlusR Center D300 HEAD POINT 10 – 32 (TYPICAL) DETAIL STRIP 2. Rack Mounted Hardware Manuals Online! – Manuals Online! – Connect music input wires to Left, Right, and Ground terminals, if stereo, or Left Ground, if not (see Figure 3). 3. Music Input Connections on AmpliCenter Hookup speaker cable to AmpliCenter (see Figure 4). The optional audio music source can be CD or tape player, AM, FM, or radio, or other audio If more than one speaker cable routed to the AmpliCenter, a block is necessary. to sample wiring diagrams on 8. It is recommended that shielded wire be used. NOT hook up speaker wires with power plug connected! 4. Speaker Connection on AmpliCenter Connect host telephone system to Amplicenter (see Figure 5). Set the AmpliCenter Telephone Mode Selection Switch (see Figure 6) to match the output type of your telephone system. power cord into AmpliCenter and into wall outlet (see Figure 7). Test paging zone served by the AmpliCenter by dialing paging telephone extension use microphone. Manuals Online! – Manuals Online! – Connect the 4-wire RJ-11 plug (used with telephones) to Page Input connector (far or use the Page in Tip and Ring if installing to an paging system (low output), VOX activated. Tip and Ring if connecting to Loop Start or Ground Start port in host telephone a microphone, hook the mic to C1 and Grd, and the mic to Tip and Ring. (cid:11) 5. Host Telephone System Connection 6. Telephone Mode Switch Setting Do not use extension or plug into locally, outlets. – 120 VAC – 2 0 VAC – 60 Hz 7. Power Cable Manuals Online! – Manuals Online! –