Valcom V-1011MR-4 4 & 8 Inch Amplified Recessed Ceiling Spkr

VSP-V-1011/V-1012 5 AMPLIFIED RECESSED CEILING SPEAKERS AMPLIFIED RECESSED CEILING SPEAKERS instructions contain the specifications and necessary to install, operate and maintain Amplified Recessed Ceiling Speakers. and installation information for the rings and backboxes used with these is also included in this document. speakers are for use with any Valcom page and are for interior use only. Amplified Recessed Ceiling Speakers are used provide one-way paging when used with a low audio input. Valcom Paging Adapters Electronic Key System Page Ports (interface may be required) PABX Page Ports (interface adapter may be Stand Alone Systems Existing 70V Paging Systems Background Music Systems Self-contained amplifier and volume control Operates on -24VDC Screw terminals for all connections Grille simulates recessed lighting fixture No visible mounting hardware due to concealed studs for the speaker and torsion Specifications Amplifier Input Impedance Amplifier Input Level Amplifier Output Ohm nominal nominal watt into 45 Ohm load Requirements to 50 degrees C to 85% non-precipitating V-1011BB – 4″ Recessed Ceiling Speaker Dia x 5.0 (19.81cm Dia. x 12.7cm D) lbs. (2.63 kg) V-1011MR – 4″ Recessed Ceiling Speaker Ring Dia x 5.0 (19.81cm Dia. x 12.7cm D) lbs. (1.09 kg) V-1012BB – 8″ Recessed Ceiling Speaker Dia x 6.0 Dia. x 15.24cm D) lbs. (2.86 kg) Ring Dia x 6.0 Dia. x 15.24cm D) lbs. (1.50 kg) V-1012MR – 8″ Recessed Ceiling Speaker Manuals Online! – DESIGN Amplified Recessed Ceiling Speakers may be to provide one-way paging from any Valcom or talkback page control. The speakers can be used to expand existing 70V paging systems. power and appropriate input signal are applied, voice page can be made. Control Access Figure 1) using the Amplified Recessed Ceiling Speakers a Valcom page control, the following equipment be required: Appropriate one-way speaker assembly Valcom page control Valcom power supply sized to provide power to the amplified speaker assemblies and control When using the Valcom one-way interior with a Valcom handsfree page control, it recommended that a V-1092 Volume Control be between the zone output and the input. or 70V Paging Systems Figure 2) using the Amplified Recessed Ceiling Speakers an existing 25 or 70V paging system, the equipment will be required: Appropriate one-way speaker assembly Valcom power supply sized to provide power to the amplified speaker assemblies or 70V line transformer tapped at 1/4 watt an 8 ohm output Valcom V-1094A Page Port Preamp/Expander Applications Tip and Ring input of the amplified speaker may connected directly to the speaker in most key telephones to amplify the level of the A power supply is also required. Cabling Valcom amplified one-way interior speakers 2 pairs to operate. Standard telephone station may be used. Existing telephone wire and cables may also be used. Refer to the tables when planning an installation. Audio Pair: The number of speakers looped on audio pair is not critical unless you have a large job. Table 1 gives guidelines for the of speakers per audio run. 1 – Number of Speakers per Audio Run AWG Run (Ft) AWG Power Pair: The cable runs specified in Table 2 very important and must be followed for operation of the one-way paging speakers. 2 – Number of Speakers per Power Run AWG) Run (Ft) Watt Inside Speakers area covered by Valcom Recessed Ceiling