Valcom v-1095

Issue 3 PAGING EXPANDER instructions contain the specifications and necessary to install, operate, and maintain V-1095 70V Paging Expander. Valcom V-1095 70V Paging Expander is used to 8 Ohm, 25V, 70V, or 100V systems into speaker assemblies. The unit comes with its surface mount box which provides 1/2″ conduit The unit will accept input signal from a 8 Ohm, 70V, or 100V paging system and reduce it to a low reduced level output. To expand existing 8 Ohm/25/70/100V paging without replacing the main amplifier. A V- preamp expander may also be required on the number of speakers added. To provide master volume control convenience to all a portion of a paging zone. x 2.75″W x 2.88″D H x 6.99cm W x 7.32cm D) lbs. (.41 kg) Specifications Impedance: 100V 70V 25V Impedance Response K Ohm K Ohm K Ohm Ohms to 20KHz +3dB instructions cover only the installation of the Valcom Consult the practices of other equipment if other is being used. and Power Connections a 25/70/100V Amplifier Amplifier Output V-1095 70V Expander (V-1095 connects to a single 25, 70, or 100V output) One-Way The V-1095 does not require a power supply. power supply is required for speaker/amplifier assemblies. Vdc Regulated Power Supply or “A” Battery 1 Manuals Online! – Mounting – Install romex connector and closure in appropriate access holes on supplied single gang electrical box. Attach mounting lugs to box with the two screws provided. Mount the box to surface with appropriate hardware. Feed audio through access hole in installed surface mount box. After making required cable connections, faceplate to box with screws provided. Mounting – Feed audio cable through access hole an existing single gang electrical workbox. After connections, attach faceplate to box using the provided. ASSISTANCE trouble is reported, verify there are no broken leading to this unit. Assistance in is available from the factory. When you should have a VOM available and be calling the job site. Call (540) 427-3900 and ask for Support, or call (540) 427-6000 for Valcom 24- Automated Support or visit our website at equipment is not field repairable. Valcom, Inc. service facilities in Roanoke, VA. Should be necessary, attach a tag to the unit clearly stating company name, address, phone number, contact and the nature of the problem. Send the unit to: Inc. and Return Dept. Hollins Road VA 24019-5056 an 8 Ohm Amplifier Output Amplifier Output Ohm V-1095 70V Expander One-Way The V-1095 does not require a power supply. power supply is required for speaker/amplifier assemblies. Vdc Regulated Power Supply or “A” Battery 2 an 8 Ohm Stereo Output Amplifier COM 8 Ohm COM 8 Ohm V-1095 70V Expander Vdc Regulated Power Supply or “A” Battery One-Way V-1095 70V Expander Vdc Regulated Power Supply or “A” Battery One-Way The V-1095 does not require a power supply. power supply is required for speaker/amplifier assemblies. 3 to the figures above for connections. Cabling “D” station wire or other suitable pairs may be used for output connection. 25V, 70V, or 100V input leads to amplifier. V-1095 output leads to speaker/ assemblies or V-1094A. Manuals Online! – audio output to added CHART input path output path