VSP 7 ZONE PAGE CONTROL V-1109RTHF, Nine Zone Page Control, is a dial microprocessor controlled page unit to be used PABX, Electronic Key or 1A2 Telephone These instructions contain the and information necessary to install, and maintain the Nine Zone Page Control. paging unit has received an FCC type KX and is designed to be used with FCC key telephone systems. In accordance with rules with applicable tariffs, this intercom unit only be installed with the authorization of the of the host system. FCC Registration Number will be listed in the filed with the telephone company; it will be recorded in the system log kept by installation maintenance personnel. The local telephone is to be notified of the FCC Registration when this intercom unit is installed. equipment generates and uses radio frequency and if not installed and used properly, that is strict accordance with the manufacturer may cause interference to radio and reception. It has been tested and found to with the limits for a Class B computing in accordance with the specifications in J of Part 15 of the FCC Rules, which are to provide reasonable protection against If this equipment does cause to radio and television reception, which be determined by turning the equipment off and the user is encouraged to try to correct the by one or more of the following Reorient receiving antenna Relocate equipment with respect to the receiver Plug equipment into different branch circuit provide nine (9) zones of voice announce with reply paging to 1A2 Key, E-Key or PABX systems. zones signaling (tone only) Dial tone Splash tone Ringback tone second repeat alert tone option Combined rotary and tone dialing Conference calling on tone dial systems (handset handset) Background music input and amplifier Built-in all call Single digit dialing Off hook speaker inhibit (1A2) The capacity of the V-1109RTHF is 9 zones and call One talkpath The maximum number of speakers on a zone are 45 Ohm talkback speakers, or forty one-way speaker assemblies. Manuals Online! – Plan dialing codes are 1-9 and 0 for all call. Materials Required the time of installation, the installer should provide following materials: Vdc power supply (if existing supply is not type connecting block pair cable with a female amphenol connector one end Twisted pair cross-connect wire H x 5.9 W x 2.1 H x 14.99cm W x 5.33cm D) lbs. (1.23 kg) Characteristics 1 impedance Tip and Ring cable length to talkback speaker Pulses Limits Ohms ft. audio pps break ratio 10% Standard dB ms ms to 50 to 85% Signals Time Requirements Valcom V-1109RTHF requires Vdc talk and Vdc signal battery. The current and voltage range is shown in Table 2 Battery Battery Battery 2 to Vdc to Vdc to 11 Vac mA. mA. mA/Lamp when working with telephone that BATTERY is NEGATIVE and is POSITIVE. System Requirements V-1109RTHF is designed to work with the – Loop start trunk position. KEY SYSTEM – C.O. line button with trunk card. KEY SYSTEM – C.O. line button on key NOTE: A 400 type line card is not used this arrangement. V-1109RTHF has background music inputs and capable of switching the music. Refer to the titled “Music Connections” for music set up connections.