Valcom v-2926

VSP-V-2926 5 INTERCOM SYSTEM OPTION BOARD V-2926 Option Board is an add-on feature for the V-2924 Expandable Zone Talkback Intercom System. The of this board provides the following supplemental features: Time sync output Custom page groups Enhanced Caller ID Flexible Architectural numbering plan to the PC Programming Tool Store user data to EEROM L x 3.0 W x 1.1 D L x 7.62cm W x 2.79cm D) lbs (.41 kg) Real time clock for SMDR printer Auto detect for Com Port or Modem Auto adjust for Daylight Savings Time Evacuation tone to specified groups Time tones to specified groups Read software/firmware revision numbers V-2924 Programming Tool is a windows based tool designed to interface with the V-2926 Option The Option Board and the Programming Tool must both be installed to access the additional features by the Option Board. All features must be set with the Programming Tool when the Option Board and Tool are installed. OF THE OPTION BOARD OF THE PROGRAMMING TOOL 1 – Option Board Location on the Control Board THE PROGRAMMING TOOL Configuration Number and CLID Programming Connection of Service Page Groups Programmed Data to File WITH THE V-2924 Communications Direct Connect, Modem Connect Dialing Method Modem Connect, Manual Connect Data to V-2924/Receive Data from V-2924 System Date and Time Software and Firmware Revision Number Communications OF THE V-2924 MODEM OPTIONS Window, Help, Exit ASSISTANCE, WARRANTY HARDWARE CONNECTIONS 2 2 3 4 4,5 6,7 7,8 8 9 Manuals Online! – OF THE OPTION BOARD Option Board must first be installed on the Control Unit Board (See Figure 1). Disconnect main power before servicing. Remove the side plate and top cover of the Control Unit and set aside. Slide small side plate upward to provide opening for Option Board connector (See Figure 1). Align J3 on the Option Board directly over J1 on the Control Board Align J4 on the Option Board directly over JP2 on the Control Board. Press Option Board firmly in place to make sure connectors are seated properly. Replace the top cover and side plate of the Control Unit and plug in the power supply. Plug PC Communication Cable (included) into P1, PC Programming Port (located on the Option Board – See 1). V-2926 Option Board requires the use of the PC Programming Tool to access the various features it provides. OF THE PROGRAMMING TOOL Computer Requirements for the Valcom V-2924 Programming Tool: (higher is recommended) Hard drive with 30 Mbytes free Mouse Mbytes of RAM (more is recommended) available serial communication port System: The Programming Tool is 32-bit and requires Windows 95, Windows 98, or Windows NT 4.0. Rev 2 Programming Tool is compatible with previous versions of hardware, however, the new hardware is compatible with previous versions of the Programming Tool. programming tool software is furnished on 1.4 MB disks and must be installed to the hard drive. To install the On the taskbar, click the Start button disk 1 Select Run Type a: (Assuming a: is the disk drive being used) Follow on-screen instructions for full installation, changing disks as the prompt requests The Valcom V-2924 Programming Tool will automatically appear in the Programs list Manuals Online! – Manuals Online! – THE PROGRAMMING TOOL On the taskbar, click the Start button, point to Programs, select Valcom V-2924 Programming Tool. The V-2924 Programming Tool splash screen appears momentarily and then the Programming screen into view Configuration begin the programming process, click on File. A pull-down menu appears allowin