Valcom v-9936a

VSP-V-9936A 4 LINE C. O. AUDIBLE RING UNIT V-9936A is a Six Line C. O. Audible Ring Unit be used with Electronic key and PABX telephone instructions contain the specifications and necessary to install, operate, and maintain Six Line C. O. Audible Ring Unit. installing the V-9936A, notify the local company with the following information: The telephone number of the lines to which the will be connected; The FCC Registration number of the V-9936A, is BAF9I7-12995-RG-N; and The ringer equivalence number (REN): 0.7B. Monitors up to six C. O. Lines or PABX station and gives a common audible tone signal a dry relay contact closure to indicate ring on any of the lines. V-9936A units may be multiplied to supervise lines. Electronic key system C. O. lines PABX trunks PABX station numbers key system C. O. lines Monitors six lines Units may be multiplied for additional lines Provides interrupted electronic warble tone for tone signaling Provides interrupted dry contact closure output to loud bells for a night switch (On/Off switch) Built-in 66 type connection block May be connected to an existing paging system Drives up to 150 Valcom One-Way Amplified Assemblies Drives up to two 45 Ohm Talkback Speakers May be used with One-way or Talkback Paging May be used with 70 Volt Paging Systems Ring tone will override any page in progress Volume control Power reversal indicator Powered by Vdc “B” battery Each V-9936A will provide signaling for six lines or extension numbers Up to four units may be multiplied for of 24 lines May be connected to one zone of a paging The V-9936A will drive two 45 Ohm Talkback or 150 one-way amplified speaker The dry contact closure is rated at 1.0 amp @ Vac, or 2.0 amps @ 24 Vdc. Manuals Online! – x 4.55″W x 2.3″ D H x 11.56cm W x 5.84cm D) lbs. (.68 kg) Requirements to Vdc “B” Battery, 200 mA. max. to 50 Degrees C to 85% non-precipitating. Valcom V-9936A is designed to monitor up to C. O. lines or PABX station numbers and will a common tone signal and contact closure any of the lines are ringing. The V-9936A be used with most telephone systems because it directly to the lines and not to the phones. tone output may be connected to speakers used for ringing, or to one zone of a paging system. dry contact closure may be used to activate loud bells, strobes, or other external equipment. outputs will provide interrupted signals any line is ringing. disable input is provided for connection of a night With no switch connected, the V-9936A signal any time a line rings in. With a switch and providing a short across the disable the unit will be inactive. Ringing following components are required to provide audible ringing over dedicated bells or V-9936A C. O. Ring Units, 1 per 6 lines Signaling Devices consisting of: Two 45 Ohm talkback speakers, or Up to 150 one-way amplified speakers, or Loud bells, buzzers, strobes, etc. as required. Power Supply: The VP-624B will power a using talkback speakers for signaling. one-way speaker assemblies or other signaling are used, additional power may be Over Paging may be connected to one zone of a Valcom or Talkback Paging System, or to the of a high powered amplifier. The following are required: V-9936A C. O. Ring Units, 1 per 6 lines VP-624B Vdc Power Supply (VP-4024B if using more than (3) V-9936A a page is in progress when an incoming call is the ring signal from the V-9936A will override the page. !”(cid:31)#(cid:13)(cid:1