Valcom VP-6124-UPS

VSP-VP-6124-UPS 2 ON OPTION FOR THE VP-6124/VP-6124-E SUPPLY VP-6124-UPS is an optional unit that allows the to supply power during a power VP-6124-UPS is comprised of a VP-6124-UPS, and a VBB-1424 (Battery Enclosure). The connects to the VP-6124 Power (to receive power to charge the batteries). below are specifications and recommendations power sources as well as precautionary Float Standby Charging Voltage: Limit: volts (13.8 per battery) mA charging mA at 27 volt final charge amp auto-reset polyswitch amp accidental reverse battery polyswitch Required to Recharge Battery battery: hours of Time Battery will Provide With four 7AH 12V batteries for 14AH total of batteries greater than 7AH is not recom- since 90% of all power outages are less than hour in length and the time to evacuate a building less than an hour. amp load draw: amp full load: hours run time hours run time To insure troublefree UPS back-up five year batteries must be replaced five from the date of manufacturing. H x 3.5 W x 2.25 D H x 8.89cm W x 5.72cm D) lbs. (1.32 kg) VP-6124-UPS (charger) is designed for wall only. Screw mounting plate to the wall the VP-6124/VP-6124-E and position the onto the mounting plate. the UPS unit securely to the bracket lip using 6-32 x 3/8″ long Phillips head self-tapping screw Place the VBB-1424 on the floor within six of the unit. Disconnect AC power from the power supply. Remove plug button from the Remove wire access cover from the Using the cable designated by the tag labeled P/N WA-784 with 4 position connector attached to VP-6124-UPS, (charger), place molex connector through the hole on the supply and connect the charger to the input connector on the VP-6124 Power Snap strain relief into place. Replace wire access cover on the Remove cover from Battery Backup. Push cable labeled Valcom P/N WA-783 with 2 connector through the hole on the Manuals Online! – enclosure and snap strain relief into Attach connector from VP-6124-UPS to battery Replace access cover. Plug power cord from VP-6124/VP-6124-E into outlet. Turn ON circuit breaker on Battery Backup. a power failure occurs, the charger beeps to personnel that the supply is operating on the and there is a 1.5 hour run time available at amp full load. Pressing the white button will mute beeping. are three (3) LEDs located on the charger. the charger is connected to the power supply, the green LED signifying the power supply and charger on line and the batteries are charging. the red LED illuminates, this denotes that the have dropped below 20 volts and the UPS into low voltage shutdown to protect the from damage. This disconnects the load. red LED will turn off and batteries reconnect power returns and the batteries are charged 25V. the battery test button illuminates the yellow if the battery is above 24 volts (signifies a good (The charger will charge the batteries to volts in a 14 hour period assuming completely batteries). must be replaced every five years. To reduce the risk of fire or injury persons, read and follow these Supplied with four (4) Union Type MX12070 Use only Union Type MX12070 Do not dispose of the batteries in a fire. The cell explode. Check with local codes for possible disposal instructions. Do not open or mutilate the batteries. Released is corrosive and may cause damage to eyes or skin. It may be toxic if swallowed. Exercise care in handling batteries in order not to the battery with conducting materials such as bracelets, and keys. The battery or may overheat and cause burns. Do not attempt to recharge the batteries provided this or identified for use with this product. batteries may lea