Valcom pagepal interface

PagePac 2 PagePal unit interfaces most telephone sys PBX KTS Centrex to virtually any public audio system addition PagePal furnishes inputs for customer background music and auxiliary inputs as an attendant microphone a radio recorded announcements Control are provided for tones generated by the PagePal can be placed on a desk or or mounted to a wall Only line level microphones may be used PagePal Access from Loop start trunk port Ground start trunk port Analog PBX station Centrex or CO lines Dry loop page ports 4 wire with contact closure controls to set attendant input and back music relative to telephone level Simplified connections via modular telephone and lugless terminal block Requirements power supply plugs into standard AC x 6.0 x 4.0 x 15.3cm x 10.2cm lbs 0.9 kg Humidity 0 to 40 32 to 104 to 95 are routed to the output with the following highest to lowest Attendant access for emergency announce Telephone Access for general paging Alert Tone 1 siren for evacuation warning Alert Tone 2 chime for time clock door bell alert etc Night bell for after hours calls to ring over the address system Music input for background music Override or busy tone is returned to the tele user if a higher priority input is active Call confirmation and preannouncement tones be optioned An optional contact closure output is provided control auxiliary equipment music page recorder logging etc Station access mode features VOX Voice Operated Switch Maximum length off hook timer Responds to open loop disconnect Dial tone detection and disconnect Loop Start Supervised LSS access mode VOX and maximum length off hook for use with a Loop Start Trunk Port Manuals Online Manuals Online Output level of output Full clockwise rotation 14 dBm gain the Main Output level first using telephone then adjust Attendant and Music Inputs for appropriate relative level Input level of Attendant Input relative to the Input Adjustment range is from 0 dBm less than 30 dBm Input level of Music Input relative to the Tele Input Adjustment range is from 0 dBm to than 30 dBm ASSISTANCE calling have a VOM and a telephone test available and call from the job site Call 540 and ask for PagePac Technical Sup or call 540 427 6000 for Valcom 24 hour Support or visit our websites at http and www valcom com repairs be necessary attach a tag to the clearly stating company name address number contact person and the nature of problem Send the unit to Repair Dept Inc Hollins Road VA 24019 5056 Access Switch Settings four position slide switch is used to select the access mode Loop Start with a Loop Start Trunk Port of a PBX or System or a dedicated phone set Start Loop Start Supervised from a PBX Ground Start Trunk Port this mode the PBX ground must be con to pin 1 of the 20 pin connector on the or pin 2 of the RJ11 connector on PagePal Loop Start Supervised mode pin 7 of the must be connected to pin 1 on the connector to allow supervision of the Start Trunk Port The PagePal will super the connection and will automatically dis the line if no voice is detected on the for 20 seconds or if the line remains active hook for more than one minute Station Access with a standard ANALOG station port a CENTREX PBX Key System or Central subscriber line Use a two wire RJ11 in this mode The PagePal receives talk and ring voltage from the host system Dry Loop with the Page Port of a PBX or Key or an Auxiliary port of a PBX This shall respond to resistances from 0 to 1K and will ignore resistance greater than Ohms Use a four wire RJ11 cable in this Dry Loop is a four wire connection 2 and 5 of the RJ11 are intended to inter with the control leads of the host system pins 3 and 4 connect to Tip and Ring as See Table 2 for pinout descriptions Manuals Online Manuals Online RECEIVER FOR ACCESS SYSTEM SOURCE LOUDSPEAKERS ADDRE SS SYSTEM AMPLIFIER S PROCESSING ON TRO L OR KEY SYSTEM E PROG RAMMED NIGHT BELL AC UTL ET 1 A G E P A L Connections to the PagePal Connectors Rear Panel View to Tables 1 and 2 for Description 2 Functional Block Diagram Manuals Online Manuals Online