Valcom v-119rt

VSP V 119RT 6 STATION ROTARY TONE INTERCOM instructions provide identification installation connection and maintenance information the V 119RT intercom unit V 119RT is a single path dial select controlled intercom unit to be used 1A2 Key Telephone Systems paging unit has received an FCC type KX and is designed to be used with FCC key telephone systems Installations may made by Valcom Inc telephone equipment telephone companies registered refurbishers and those qualified for of FCC registered systems under FCC Section 68.215 accordance with FCC rules with applicable tariffs intercom unit may only be installed with the of the owner of the host system FCC Registration Number will be listed in the affidavits with the telephone company it will also be in the system log kept by installation and personnel The local telephone is to be notified of the FCC Registration when this intercom unit is installed equipment generates and uses radio frequency and if not installed and used properly that is strict accordance with the manufacturer may cause interference to radio and reception It has been tested and found to with the limits for a Class B computing in accordance with the specifications in J of Part 15 of the FCC Rules which are to provide reasonable protection against interference If this unit does cause interference radio and television reception which can be by turning the equipment off and on the is encouraged to try to correct the interference by or more of the following measures Reorient the receiving antenna Relocate the equipment with respect to the Plug the equipment into a different branch Move the equipment away from the receiver To provide 19 stations of intercom signaling to key systems key systems stations or zones Dial tone Ringback tone Last number dialed re ring tone only Conference calling on tone dial systems Personal signaling tone only Combined rotary and tone dialing The capacity of the V 119RT is 19 stations One talkpath Manuals Online mA 45 mA lamp mA Plan The dialing codes are 0 1 3 9 20 29 H x 5.9 W x 2.1 D H x 14.99cm W x 5.33cm D lbs 1.6 kg Requirements Working Limits Current to Vdc battery to Vdc battery battery 9V to 11 Vac Characteristics Working Limits Imp T and R Ohm incl inst Contacts amps Time sec Pulses PPS Break ratio Signals Standard Time MS MS to 50 C to 85 Non precip instructions cover only the installation for the Valcom V 119RT Consult installation instructions for other equipment that be used precautions have been taken at the factory to that the equipment functions properly To proper operation and to prevent equipment please observe the following Unplug the power supply before making any to the control unit Do not locate the control unit closer than 18 or farther than 5 feet from the power Do not use a lamp tester to check signals use a A lamp tester when first applied is a circuit to electronic circuits Do not apply power to the control unit until all have been double checked the V 119RT on a 7 KTU mounting relay or on the wall 1 a 25 pair female amphenol ended to the unit and terminate all leads on a type block A ground B ground and lamp ground signal ground common at power to Figure 1 for connecting block and connections to Figure 2 for connections to 1A2 Systems 2 3 4 place an intercom call go off hook and dial tone be heard Dial the number of the desired zone or Dial tone will be broken after the first is dialed A one second ringback tone will that the called station is being signaled Number Dialed Re Ring re ring the same station press the button The will be signaled as long as the is pressed Signaling initiating a call press the and then the number A double tone will be sent to the station Calling dial a new number tone dial only or to initiate a call press the button Dial tone will returned to the calling party Dial new number Manuals Online DESCRIPTION unit provides the common equipment necessary supply 19 stations of dial select intercom when to 1A2 or equivalent telephone systems Description a station user lifts handset to make an ICM the switchhook contacts in the telephone close tip and ring to form a loop which returns battery to turn on a transistor which operates relay and circuit to return dial tone and lamp battery to set The logic circuit receives dialing and operates relays and circuitry to ringing or buzzer voltage to the station ASSISTANCE trouble is reported verify that All telephone sets are in proper working order Power is being supplied to the unit There are no broken connections at the block The conductors of color coded cables are in the proper order trouble still exists the test equipment listed below be required Volt ohm multimeter Tone dial single line instrument for tone dial Telephone test set Clip leads lamps must not be used to check voltages They damage electronic circuits When a hand test set used to check voltages the results will be proceeding further check the voltages at the block An undetected blown fuse or low will cause improper control operation DC measurements are made with respect to the trouble has not been located refer to Table 1 chart identifies symptoms of some possible and solutions a spare unit is available continue to troubleshoot substituting the spare unit for the specified unit after all the required tests have been performed trouble still exists assistance in troubleshooting is from the factory When calling you should a VOM a telephone test set and several clip available and be calling from the job site Call 427 3900 and ask for Technical Support or 540 427 6000 for Valcom Automated Support visit our website at http www valcom com V 119RT is not field repairable Valcom contains no user serviceable parts Valcom Inc maintains service facilities in VA Should repairs be necessary attach a indicating company name address phone contact person and the nature of the Send the unit to Inc and Return Dept Hollins Road VA 24019 5056 Manuals Online 1 CHART CAUSE AND CORRECTION A battery connections polarity and voltage B battery connections polarity and voltage side tone dial tone lamps lamp supply voltage and input Verify that grounds are common at supply audible signal at station signal voltage at supply and frame locations Verify that grounds are at power supply Inc warrants its products to be free from defects in materials and workmanship under conditions of normal use and service a period of one year from the date of shipment The obligation under this warranty shall be limited to the replacement repair or of any such defective device within the warranty period provided that LIMITED WARRANTY by Valcom Inc indicates the validity of the claim defect is not the result of damage misuse or negligence after the original shipment product has not been altered in any way or repaired by others and that factory sealed units are unopened A service plus parts and labor will be applied to units defaced or physically damaged charges for the return of products to Valcom are prepaid units of war