Valcom v-9010

T ASSISTANCE trouble is reported verify there are no broken connections to the unit in troubleshooting is available from the factory When calling you should a VOM and a lineman test set available and be calling from the job site Call 427 3900 and ask for Technical Support or call 540 427 6000 for Valcom Automated Support or visit our website at http www valcom com equipment is not filed repairable Valcom Inc maintains service facilities in VA Should repairs be necessary attach a tag to the unit clearly stating your name address phone number contact person and the nature of the problem the unit to Inc and Return Dept Hollins Road VA 24019 5056 LIMITED WARRANTY Inc warrants its products to be free from defects in materials and workmanship conditions of normal use and service for a period of one year from the date of The obligation under this warranty shall be limited to the replacement repair refund of any such defective device within the warranty period provided that by Valcom Inc indicates the validity of the claim defect is not the result of damage misuse or negligence after the shipment product has not been altered in any way or repaired by others and that sealed units are unopened A service charge plus parts and labor will applied to units defaced or physically damaged charges for the return of products to Valcom are prepaid units of warranty are subject to a service charge The service charge cover minor repairs Major repairs will be subject to additional charges for and labor warranty is in lieu of and excludes all other warranties expressed or implied in no event shall Valcom Inc be liable for any anticipated profits damages loss of time or other losses incurred by the buyer in with the purchase operation or use of the product warranty specifically excludes damage incurred in shipment In the event a is received in damaged condition the carrier should be notified immediately for such damage should be filed with the carrier involved in accordance with the point Inc Industry Avenue VA 24013 540 427 3900 540 427 3517 Canada Corporation Van Kirk Drive 11 and 12 Ontario L7A1A5 905 456 1072 905 456 2269 INSTRUCTIONS FOR MOUNT RESISTANT SPEAKER MODEL NO V 9010 3 VANDAL RESISTANT SPEAKER Valcom Surface Mount Vandal Resistant Speaker V 9010 was designed to be in harsh environments The speaker assembly features a steel housing a built in an interior security screen and tamper resistant screws steel housing is constructed of 18 gauge steel finished with a baked on powder urethane finish The screen is made of 24 gauge steel to prevent sharp object penetrating the speakers making connections to the speaker secure the enclosure assembly to the base four 10 stainless steel hex button head machine screws using a standard 1 8 hex base of the V 9010 will mount to a standard 4 inch square or octagon shaped box or may be fastened to a wall or ceiling using screws as large as Surface wiring or conduit is routed through one of four standard knockouts Rating Watt Voltage Consumption ma Response Power Hz 6.5 kHz Watt dB at 1 Watt 1 Meter Coil Weight Material Ohm oz The V 9010 may be used to expand a constant voltage 25 70 100 volt system without placing an additional load on the amplifier by adding a V 70V Paging Expander A power supply will also be required Page Control 24 Vdc Power Supply Dia x 5.1 21.59cm Dia x 12.95cm D lbs 2.18 kg CHART No audio from Check that volume control is turned up clockwise Using a lineman test set check for the proper audio on the Tip and Ring leads and also at the Low volume speaker Check that volume control is turned up Check voltage at the speaker assembly when in use to 24VDC required Using a lineman test set check for proper audio on Tip and Ring leads It is possible that some level audio will be heard with only one side of and Ring connected Loud squeal Turn down counter clockwise volume of the the distance between the telephone and the a noise canceling handset on the telephone in problem areas a V 9962 Digital Feedback Eliminator