DSC PC510 v1 0 - Installation Manual - English - ClassicSeries 4 Zone Alarm Control Panel

Software Version 1 O W A R N I N G manual contains information on limitations regarding product use function and information on the limitations as to liability of the The entire manual should be carefully read OF CONTENTS 2 2 the Panel 3 the Keypad 3 4 Zone Wiring 4 Power Connection 4 Terminal Connections 4 Power Wiring 4 Connection 4 Terminal Connection 4 FUNCTIONS 5 Code 5 Programming Code 5 5 Arming 5 Arming 5 6 Quick Arm 6 Code Zone Bypassing 6 Display Trouble Conditions 6 Display Alarm Memory 6 Bell Test 6 Code Program Access Codes 7 Door Chime On Off 7 Utility Output Command 7 Code Installer Programming Command 7 Code At Home Arming 7 Zones 8 the Keypad Sounder Tone and Backlighting 8 GUIDE 5 Enabling System Functions 9 Programming to the Factory Default Settings 9 SECTIONS Zone Definitions 10 System Times 11 Installer Code 11 Programmable Output Options PGM1 and PGM2 Terminals 11 1st System Option Code 12 THE RECORD WORKSHEET DIAGRAM WARRANTY Fully featured security system with Trouble Alarm Memory Master Code and 3 Access Codes Quick Arming and Arming Door Chime 3 one touch Keypad and more 4 End of Line Resistor Supervised Zones 6 Programmable Zone Types with Fast and Slow times and Silent or Audible alarms 2 Programmable Outputs with 9 options Momentary or Maintained Keyswitch Arming All Installer Programming is performed at the EEPROM memory retains all programming even all power is removed from the control panel Advanced static and lightning protection unique circuit board design stops damaging at the wiring terminals and transient devices are placed in all critical areas for protection Control Panel Four fully programmable zones Zones are End of Line Resistor supervised Maximum zone loop resistance 100 ohms Bell Siren Output fused for 5A Bell Siren Alarms steady and pulsed alarms Programmable Output 50 mA with 9 options Auxiliary Power Output 800 mA with 40 VA transformer 500 mA with 20 VA transformer Maximum 3 Keypads per system and Keyswitch Required Battery 12 VDC 1.2 Ah provides 4 hours of stand by at mA Auxiliary Output 4.0 Ah provides 4 hours of stand by at mA Auxiliary Output Required Transformer 16 VAC 20 40 VA Panel dimensions 7 high 9 wide 3 deep 178 229 76 mm Panel Colour light beige Keypad 12 key keypad Three one touch Zones F A P 3 Status Lights Ready Armed System 4 Zone Lights All new slimline design Keypad dimensions 4.75 high 2.75 wide 1.2 120mm 70mm 30mm Keypad Colour Designer White with Grey display Keypad 12 key keypad Three one touch Zones F A P 3 Status Lights Ready Armed System 4 Zone Lights Nominal current consumption 30 mA Keypad dimensions 4.5 high 4.5 wide 1 114mm 114mm 25.4mm Keypad Colour Mist the Panel a dry location close to an unswitched AC source and a ground connection the printed circuit board mounting hardware and keypad from the cardboard retainer inside the panel cabinet Before attaching the cabinet to the wall press the four white nylon printed circuit board studs into the raised mounting holes from the back of the cabinet Also secure the ground screw to hole in the cabinet the cabinet in position and pull all wires into the cabinet Mount the cabinet securely to the wall using the screws provided It is recommended that appropriate wall anchors be used when