DSC PS1520 - Installation Manual - English - Power Supply (1 5 Amp Supply)

PS152O Supply N S T A L L A T I O N I N S T R U C T I O N S PS1520 is a 1.5 amp regulated power supply with a built in battery charging and AC power indicator The board is 6.6cm 2.6 x 5.1cm 2.0 and comes adhesive foam mounting tape 6 or 12 volt operation jumper selectable Provides correct charging voltage for rechargeable gell cell batteries Trimpot for lead acid batteries AC power on LED indicator Automatic switch over to standby battery power in case of AC power failure Output is fused at 3 amps for higher battery assisted output current Instructions the time of installation select proper operating voltage For 6 volt operation leave yellow jumper intact For 12 volt operation cut yellow jumper AC power only without battery connected DC voltage and load current From the or estimated load current you can obtain transformer and battery requirements battery and remove AC power The circuit operate normally Reconnect the AC power circuit is now fully tested and functional Requirements For maximum power 6 VDC 12 volts 40 VA 12 VDC 16 volts 40 VA WARRANTY Security Controls Ltd warrants that for a period of twelve 12 months from the date of purchase by the buyer the product shall be free of defects in materials and workmanship under normal use and that of any breach of such warranty Digital Security Controls Ltd shall at its option repair or replace defective equipment upon return of the equipment to its factory This warranty applies only to defects in and workmanship and not to damage incurred in shipping or handling or damage due to causes beyond control of Digital Security Controls Ltd such as lightning excessive voltage mechanical shock water or damage arising out of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other whether expressed or implied and of all other obligations or liabilities on the part of Digital Controls Ltd This warranty contains the entire warranty Digital Security Controls Ltd neither nor authorizes any other person purporting to act on its behalf to modify or change this warranty or concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages loss anticipated profits loss of time or any other losses incurred by the buyer in connection with the purchase or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be tested on a regular basis despite frequent testing and due to but not limited to criminal tampering or electrical disruption is possible for this product to fail to perform as expected Supply N S T A L L A T I O N I N S T R U C T I O N S PS1520 is a 1.5 amp regulated power supply with a built in battery charging and AC power indicator The board is 6.6cm 2.6 x 5.1cm 2.0 and comes adhesive foam mounting tape 6 or 12 volt operation jumper selectable Provides correct charging voltage for rechargeable gell cell batteries Trimpot for lead acid batteries AC power on LED indicator Automatic switch over to standby battery power in case of AC power failure Output is fused at 3 amps for higher battery assisted output current Instructions the time of installation select proper operating voltage For 6 volt operation leave yellow jumper intact For 12 volt operation cut yellow jumper AC power only without battery connected DC voltage and load current From the or estimated load current you can obtain transformer and battery requirements battery and remove AC power The circuit operate normally Reconnect the AC power circuit is now fully tested and functional Requirements For maximum power 6 VDC 12 volts 40 VA 12 VDC 16 volts 40 VA WARRANTY Security Controls Ltd warrants that for a period of twelve 12 months from the date of purchase by the buyer the product shall be free of defects in materials and workmanship under normal use and that of any breach of such warranty Digital Security Controls Ltd shall at its option repair or replace defective equipment upon return of the equipment to its factory This warranty applies only to defects in and workmanship and not to damage incurred in shipping or handling or damage due to causes beyond control of Digital Security Controls Ltd such as lightning excessive voltage mechanical shock water or damage arising out of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other whether expressed or implied and of all other obligations or liabilities on the part of Digital Controls Ltd This warranty contains the entire warranty Digital Security Controls Ltd neither nor authorizes any other person purporting to act on its behalf to modify or change this warranty or concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages loss anticipated profits loss of time or any other losses incurred by the buyer in connection with the purchase or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be tested on a regular basis despite frequent testing and due to but not limited to criminal tampering or electrical disruption is possible for this product to fail to perform as expected 1997 2002 Digital Security Controls Ltd Canada cid 127 www dsc com Support 1 800 387 3630 in Canada 29000037 R1 1997 2002 Digital Security Controls Ltd Canada cid 127 www dsc com Support 1 800 387 3630 in Canada 29000037 R1